Abstract:When circulating degassing or emergency blowout is required during oil and natural gas drilling, it is necessary to use separation equipment to separate waste gas, waste liquid, natural gas, or other impurities to avoid environmental pollution caused by the combustion of mixed fluids. In this paper, a structural scheme of spindle-shaped axial gas–liquid cyclone separator is proposed, and the Reynolds stress model (RSM) and DPM model are used to numerically simulate the gas–liquid two-phase flow, the flow field distribution law of the separator is obtained, the influence of structural parameters on the flow field is analyzed, and the multiobjective and multiparameter structure optimization research of the separator is carried out by orthogonal test method. Through the extreme difference analysis and ANOVA, the optimal level of separation performance of the separator was obtained by the combination of parameters B3A3C2, i.e., the combination of parameters with the outlet angle of 60°, the number of blades of 6, and the ratio of the length of the separation chamber to the depth of the overflow pipe M of 0.4, and the design and optimized structure were verified by the field experiments. The results show that the velocity in the cyclone separator is approximately “ M ” type distribution, and the velocity decays gradually along the axial direction due to energy loss. With the increase of the inlet gas velocity, the tangential velocity in the separator increases, and the separation efficiency and pressure drop increase. At the same time, with the increase of particle diameter, the centrifugal force of particles increases, the number of particle “escapes” decreases, and the separation efficiency increases, but the particle diameter has little effect on pressure drop. After the optimization of the structure, the separation efficiency is improved, the pressure drop is also reduced, and the comprehensive working performance of the separator is significantly improved.

Structural Optimization of Downhole Oil-Water Separator

Optimizing Design for Downhole Oil-Water Separation

Structural parameter optimization of downhole dual-stage tandem hydrocyclone

Structural Optimization for an Axial Oil‐water Separator with Multi‐stage Separation

Research on structural parameter optimization of a new axial inlet hydrocyclone separator based on response surface optimization method

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

Design of an Axial Hydrocyclone for Preliminary Water Separation Using CFD, RSM, and SUS

Optimal Design of the Linkage Between Two Downhole Hydrocyclones in Series

SIMULATION ANALYSIS AND STRUCTURAL OPTIMIZATION FOR OIL-WATER SEPARATION HYDROCYCLONE

A Novel Oil–water Separator Design and Its Performance Prediction

A Novel Oil-Water Separator Design Based on the Combination of Two Flow Resistance Mechanisms

Structural Parameter Optimization of the Helical Blade of the Variable-Pitch, Downhole, Cyclone Separator Based on the Response Surface Method

The numerical simulation and structural optimization of downhole oil-gas hydrocyclone

Optimum design of inline gas-liquid cyclone separator for wide range of inlet gas volume fractions

Working Performance and Structure Optimization of Spindle-Shaped Axial Gas–Liquid Cyclone Separator

Multi-objective optimization of axial-flow-type gas-particle cyclone separator using response surface methodology and computational fluid dynamics

Development of Hydrocyclone's Optimize-Design System Based on CFD

Structural Optimization of a Demulsification and Dewatering Device Coupled with Swirl Centrifugal and High-Voltage Fields by Response Surface Methodology Combined with Numerical Simulation

Multi-objective optimization investigation on wave plate separator by using Taguchi method

Experimental Study on the Design of Light Phase Outlets for a Novel Axial Oil-Water Separator

Optimization of Dividing Wall Columns Based on Online Kriging Model and Improved Particle Swarm Optimization Algorithm