Abstract:Ultra-high performance concrete (UHPC) is characterized by its ultra-high strength and durability, making it suitable for use in large-span bridges, super high-rise buildings, and other special structures. These types of structures often have high requirements for crack control, making the exploration of UHPC's fracture mechanics properties of significant importance. Therefore, this paper sets up four steel fiber contents (0%, 0.6%, 1.2% and 1.8%) and four strain rates (10-5/s, 10-4/s, 10-3/s and 10-2/s), totaling 16 working conditions. The hydraulic servo system combined with digital image correlation (DIC) technology was used to conduct fracture mechanics tests on UHPC three-point bending beams. The test results show that the unstable fracture load of UHPC increases with the increase of strain rate and steel fiber content, and increasing the steel fiber content can enhance the strain rate effect of UHPC to a certain extent. Additionally, combined with the J-criterion model, this study proposed a dynamic criterion for the unstable fracture load of UHPC considering the influence of steel fiber content. The initial fracture toughness, unstable fracture toughness, and fracture energy of UHPC are significantly more affected by steel fiber content than by strain rate. Through DIC technology, the analysis of UHPC crack propagation shows that UHPC without steel fibers experiences rapid crack expansion in the Pre-90% to Peak stage, with less influence from the strain rate. However, UHPC with steel fibers exhibits a more uniform crack growth rate, with the crack emergence phase gradually lagging as the strain rate increases. For UHPC without steel fibers, the crack opening displacement (COD) at the unstable fracture load point surges suddenly, while the COD development in UHPC with steel fibers is slower. At lower strain rates, an increase in steel fiber content leads to an earlier sudden increase phase in UHPC's COD; at higher strain rates, the influence of steel fiber content on the sudden increase phase of UHPC's COD is more scattered. The research results of this paper provide a theoretical basis for the calculation and analysis of the dynamic response of UHPC structures under seismic loads.

Influence of Steel Fiber on Dynamic Compressive Behavior of Hybrid Fiber Ultra High Toughness Cementitious Composites at Different Strain Rates

Contribution of Steel Fiber on the Dynamic Tensile Properties of Hybrid Fiber Ultra High Toughness Cementitious Composites Using Brazilian Test

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Comparative study on effects of steel fiber and imitation steel fiber on dynamic tensile properties of ultra-high-performance cementitious composites

Influence of Fiber Type on Mechanical Properties of Lightweight Cement-Based Composites

Direct tensile behavior of steel fiber reinforced ultra-high performance concrete at high strain rates using modified split Hopkinson tension bar

Influence of Hybrid Fibers on Flexural Properties of Ultra High Toughness Cementitous Composites with Nano-SiO2

A Study of Strain-Rate Effect and Fiber Reinforcement Effect on Dynamic Behavior of Steel Fiber-Reinforced Concrete

Hybrid effects of carbon nanotubes and steel fiber on dynamic mechanical properties of ultra-high performance concrete

Bending Fatigue Properties of Ultra-High Toughness Cementitious Composite (UHTCC)

Experimental Investigation on Strain Rate Effect of High-Performance Fiber Reinforced Cementitious Composites Subject to Dynamic Direct Tensile Loading

Experimental and numerical study on tensile strength and failure pattern of high performance steel fiber reinforced concrete under dynamic splitting tension

Multiscale Insights on Enhancing Tensile Properties of Ultra-High Performance Cementitious Composite with Hybrid Steel and Polymeric Fibers

Steel Fiber-Reinforced Concrete under Impact Loading Dynamic Constitutive Equation

Dynamic tensile properties of steel fiber reinforced polyethylene fiber-engineered/strain-hardening cementitious composites (PE-ECC/SHCC) at high strain rate

Effect of Fiber Content and Fiber Length on the Dynamic Compressive Properties of Strain-Hardening Ultra-High Performance Concrete

Study on the Dynamic Fracture Mechanical Properties of Ultra High-Performance Concrete under the Influence of Steel Fiber Content

Fiber Synergy of Polyvinyl Alcohol and Steel Fibers on the Bond Behavior of a Hybrid Fiber-Reinforced Cementitious Composite

Experimental Study on Dynamic and Static Mechanical Properties of Steel Fiber Reinforced Concrete

Effects of Steel Fiber Content on Compressive Properties and Constitutive Relation of Ultra-High Performance Shotcrete (UHPSC)

Coupled Effects of High Temperature and Strain Rate on Compressive Properties of Hybrid Fiber UHTCC