Abstract:This work investigates the effects of gas preheating and N2 dilution on soot formation in a series of laminar methane (CH4), ethane (C2H6), and propane (C3H8) co-flow diffusion flames. A modified Santoro-type burner was used to produce the flames with a series of preheat temperatures of both co-flow air and inlet fuels between 293 and 723 K. Planar laser-induced incandescence and line-of-sight beam extinction were employed to quantitatively measure the planar distributions of soot volume fractions, and two-color pyrometry was used to measure the soot temperature. The results show that the soot volume fraction significantly increases with the gas preheat temperature for all flames. A rise in the preheat temperature accelerates soot evolution and leads to the higher percentage of carbon conversion to soot in the flames. This enhancement is more remarkable in the flames of fuel with a lower sooting propensity than those with a high sooting propensity. Both axial and radial soot temperatures in the CH4 and C2H6 flames increase with the gas preheat temperature significantly. However, a reverse changing trend is observed in the central region of C3H8 flames, owing to the greater heat losses resulting from the incomplete combustion and strong soot radiation. Adding N2 to the fuel flow suppresses soot formation via the direct dilution effect on the fuel concentration and the indirect effect of changing the flame temperature. As the gas preheat temperature increases, an increasing proportion of the contribution of the direct dilution effect is observed in the N2-diluted C2H6 flames. In addition, the global activation energy of soot formation for the three fuels is estimated on the basis of the measured soot temperature and soot formation rate in the present work.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.0c03426?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.0c03426</a>.Calculated pyrolysis products for (a) CH4, (b) C2H6, (c) N2-diluted (50%) C2H6, (d) C3H8, and (e) N2-diluted (66.7%) C3H8 under different temperatures (Figure S1), relationship between laser fluence and normalized LII signal intensity (Figure S2), vertical laser fluence profile of the laser sheet where the laser fluence was set as approximately 0.3 J/cm2 (Figure S3), and calibrated relationship between soot volume fraction (fv) and LII signal intensity at the height from 15 to 40 mm in the propane flame IV-0, with the solid line representing the fitting curve to the experimental data and the two short dashed lines representing the boundaries of ±15% uncertainty in the fitting correction factor (Figure S4) (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.0c03426/suppl_file/ef0c03426_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Effect of Methane Doping on Nascent Soot Formation in Ethylene-Based Laminar Premixed Flames

Effect of Dimethyl Ether (DME) Addition on Sooting Limits in Counterflow Diffusion Flames of Ethylene at Elevated Pressures

Effect of Methane Addition to Ethylene on the Morphology and Size Distribution of Soot in a Laminar Co-Flow Diffusion Flame

Role of Dimethyl Ether in Incipient Soot Formation in Premixed Ethylene Flames

Effect of Mixing Methane, Ethane, Propane and Ethylene on the Soot Particle Size Distribution in a Premixed Propene Flame

Effects of Blending Methane, Propane, and Propylene on Soot Evolution in Ethylene Diffusion Flames Based on Optical Diagnostics

Soot formation characteristics of ethylene premixed burner-stabilized stagnation flame with dimethyl ether addition

Study of soot microscopic characteristics in hydrogen/methane/ethylene co-flow diffusion flame

Effect of Dimethyl Ether Addition on Soot Formation Dynamics of Ethylene Opposed-Flow Diffusion Flames

Numerical Study of Soot Formation in Laminar Coflow Diffusion Flames of Methane Doped with Primary Reference Fuels

Synergistic Effect of Mixing Ethylene with Propane on the Morphology and Nanostructure of Soot in Laminar Coflow Diffusion Flames

Numerical Investigation of Soot Formation in a Methane Diffusion Flame Doped with N-Heptane at Elevated Pressure

In-situ Laser Diagnostic and Numerical Investigations of Soot Formation Characteristics in Ethylene and Acetylene Counterflow Diffusion Flames Blended with Dimethyl Carbonate and Methyl Formate

The Influence of Dimethoxy Methane (dmm)/dimethyl Carbonate (DMC) Addition on a Premixed Ethane/oxygen/argon Flame

The Effects of 1-Methylnaphthalene Addition to N-Dodecane on the Formation of Soot and Polycyclic Aromatic Hydrocarbons in Laminar Coflow Diffusion Flames

Simulation of primary particle size distributions in a premixed ethylene stagnation flame

Study of Soot Functional Groups and Morphological Characteristics in Laminar Coflow Methane and Ethylene Diffusion Flames with Hydrogen Addition

Effects of the Gas Preheat Temperature and Nitrogen Dilution on Soot Formation in Co-flow Methane, Ethane, and Propane Diffusion Flames

Numerical study on the temperature dependence of soot formation in acetylene pyrolysis blended with methane, formaldehyde, methanol, and dimethyl ether

Experimental study on the effect of hydrogen addition on methane/ethylene diffusion flame soot formation based on light extinction measurement

Comparative Study on Nascent Soot Formation Characteristics in Laminar Premixed Acetylene, Ethylene, and Ethane Flames