Abstract:An electrochemical carbon nanotube filter has been reported to be effective for the removal and electrooxidation of aqueous chemicals and microorganisms. Here, we investigate how carbon nanotube (CNT) chemical surface treatments including calcination to remove amorphous carbon, acid treatment to remove internal residual metal oxide, formation of surficial oxy-functional groups, and addition of Sb-doped SnO(2) particles affect the electrooxidative filter performance. The various CNT samples are characterized by scanning electron microscopy (SEM), thermogravimetric analysis (TGA), and X-ray photoelectron spectroscopy (XPS) and electrochemically evaluated by cyclic voltammetry, open circuit potential versus time analysis, and electrochemical impedance spectroscopy. Voltammetry results indicate that the near CNT surface pH is at least two units lower than the bulk pH. The electrooxidative performance of the various CNT samples is evaluated with 1 mM of methyl orange (MO) in 100 mM sodium sulfate at a flow rate of 1.5 mL min(-1). At both 2 and 3 V, the efficacy of electrochemical filtration is observed to be function of CNT surface chemistry. The samples with the greatest electrooxidation were the calcinated then HCl-treated CNTs, i.e., the CNTs with the most surficial sp(2)-bonded carbon, and the Sb-SnO(2)-coated CNTs, i.e., the CNTs with the most electrocatalytic surface area. At 3 V applied voltage, these CNT samples are able to oxidize 95% of the influent MO within the liquid residence time of <1.2 s. The broader applicability of electrochemical filtration is evaluated by challenging the C-CNT-HCl and C-CNT-HNO(3) networks with various organics including methylene blue, phenol, methanol, and formaldehyde. At 3 V applied voltage, both CNTs are able to degrade a fraction of all the organics with the extent organic degradation dependent on both CNT and organic properties. The C-CNT-HCl network generally had the better oxidative performance than the C-CNT-HNO(3) network with an exception being the positively charged methylene blue. The extent of MO degradation, steady-state current, anode potential, effluent pH, and back pressure are also measured as a function of applied voltage (1-3 V) and CNT surface chemistry. Mass spectrometry of electrochemical CNT filter effluent at 2 and 3 V is utilized to evaluate plausible electrooxidation products. Energy consumption as compared to state-of-the-art electrodes and strategies to tailor the CNT surface for a specific target molecule are discussed.

Removal of Ozone by Carbon Nanotubes/Quartz Fiber Film.

Carbon Nanotubes / Activated Carbon Fiber Based Air Filter Media for Simultaneous Removal of Particulate Matter and Ozone

Ozone Assisted Oxidation of Gaseous PCDD/Fs over CNTs-containing Composite Catalysts at Low Temperature.

Nanoscale discharge electrode for minimizing ozone emission from indoor corona devices.

Enhancement of Formaldehyde Removal by Activated Carbon Fiber Via in Situ Growth of Carbon Nanotubes

Efficient Catalytic Removal of Airborne Ozone under Ambient Conditions over Manganese Oxides Immobilized on Carbon Nanotubes

Ultraviolet/ozone and oxygen plasma treatments for improving the contact of carbon nanotube thin film transistors

Ozonation of indigo enhanced by carboxylated carbon nanotubes: performance optimization, degradation products, reaction mechanism and toxicity evaluation.

Electrochemical Carbon Nanotube Filter Oxidative Performance As A Function of Surface Chemistry

The effect of ozone oxidation on single-walled carbon nanotubes

Use of Carbon Nanotube Filter in Removing Bioaerosols

Hierarchical carbon-nanotube/quartz-fiber films with gradient nanostructures for high efficiency and long service life air filters

In Situ Fabrication Of Depth-Type Hierarchical Cnt/Quartz Fiber Filters For High Efficiency Filtration Of Sub-Micron Aerosols And High Water Repellency

Electron Transfer Trade-offs in MOF-Derived Cobalt-Embedded Nitrogen-Doped Carbon Nanotubes Boost Catalytic Ozonation for Gaseous Sulfur-Containing VOC Elimination

Enhanced Degradation and Mineralization of 4-Chloro-3-methyl Phenol by Zn-CNTs/O3 System.

Removal of Carbon Nanotubes from Aqueous Environment with Filter Paper.

Carbon Nanotube Films with Fewer Impurities and Higher Conductivity from Aqueously Mono-Dispersed Solution via Two-Step Filtration for Electric Heating

Removal of the Residual Surfactants in Transparent and Conductive Single-Walled Carbon Nanotube Films

Mechanism of surface treatments on carbon nanotube transparent conductive films by three different reagents

Enhanced catalytic ozonation performance by CuOx nanoclusters/TiO2 nanotube and an insight into the catalytic mechanism

Unlocking efficient and robust ozone decomposition with CNT-confined manganese oxide via synergistic electronic modulation