Abstract:The three-dimensional unsteady incompressible Reynolds-averaged Navier-Stokes equations and k-epsilon double equations turbulent model were used to investigate the effect on the measurements of anemometers due to a passing high-speed train. Sliding mesh technology in Fluent was utilized to treat the moving boundary problem. The high-speed train considered in this paper was with bogies and inter-carriage gaps. Combined with the results of the wind tunnel test in a published paper, the accuracy of the present numerical method was validated to be used for further study. In addition, the difference of slipstream between three-car and eight-car grouping models was analyzed, and a series of numerical simulations were carried out to study the influences of the anemometer heights, the train speeds, the crosswind speeds and the directions of the induced slipstream on the measurements of the anemometers. The results show that the influence factors of the train-induced slipstream are the passing head car and tail car. Using the three-car grouping model to analyze the train-induced flow is reasonable. The maxima of horizontal slipstream velocity tend to reduce as the height of the anemometer increases. With the train speed increasing, the relationship between V-train and V-induced (slipstream) can be expressed with linear increment. In the absence of natural wind conditions, from the head car arriving to the tail car leaving, the induced wind direction changes about 330 degrees, while under the crosswind condition the wind direction fluctuates around -90 degrees. With the crosswind speed increasing, the peaks of V-X, \V-XY - V-wind\ of the head car and that of V-X of the tail car tend to enlarge. Thus, when anemometers are installed along high-speed railways, it is important to study the effect on the measurements of anemometers due to the train-induced slipstream.

Impact Analysis of Pressure Sensor Size on Measurement of the High-Speed Train Aerodynamic Performance Test.

Waterproof, Anti‐Impacted, and Ultrathin Carbon‐Based Air Pressure Sensors Toward Aerodynamic Tests on High‐Speed Trains

An FBG-Based Sensor Tailor-Made for Wind Pressure Monitoring of High-Speed Trains

Influence of the sampling tube diameter and length on the measurement of surface pressure for trains

Investigation of transient aerodynamic pressure of a high-speed train nose passing from a stationary one in a high-speed rotary scaled test setup

Effect On Measurements Of Anemometers Due To A Passing High-Speed Train

Wind tunnel test on aerodynamic characteristic of CRH2 train based on pressure measure ment methodology

Influence of Various Factors on the Air Pressure Pulse from Passing Trains

Scale effect analysis in aerodynamic performance of high-speed train

A New Method to Measure the Aerodynamic Drag of High-Speed Trains Passing Through Tunnels

Aerodynamic Simulation of the Air Flow Beneath the High Speed Train

Numerical Investigation of the Aerodynamic Characteristics of a Train Subjected to Different Ground Conditions

Numerical Analysis of High-Speed Train Induced Aerodynamic Load on Noise Barrier Considering Wind Effect

Influence of Ground Effect in Wind Tunnel on Aerodynamics of High Speed Train

Influences of High-Speed Train Speed on Tunnel Aerodynamic Pressures

Numerical Study on Aerodynamic Pressure Caused by High-Speed Train Passing Through the Subway Station

Air Pressure and Comfort Study of the High-Speed Train Passing Through the Subway Station

A study on the airtightness of a high-speed train using a reduced-scale method

Field Measurements of Aerodynamic Pressures in High-Speed Railway Tunnels

Study on Spatial Distribution of Instantaneous Pressure Pulse Caused by Two Meeting Trains

Model experiment and numerical simulation of the aerodynamic character of high-speed train in tunnel