Dynamic Target Simulation System for Automotive Millimeter Wave Radar
Weigang Shi,Li Liu,Yafei Shen,Huanlei Chen,Zhuoping Yu
DOI: https://doi.org/10.1109/piers53385.2021.9694845
2021-01-01
Abstract:Automotive millimeter wave radars are currently widely used in Advanced Driving Assistance Systems (ADAS), such as in ACC, AEB, BSD and other systems. Millimeter wave radars mainly complete target detection and environmental perception tasks. The output data includes relative distance, relative angle, relative speed, radar reflection cross-sectional and other parameters, which then will be handed over to the controller to complete the target calculation. Finally, it will formulate the corresponding control strategy to issue the actuator. As the main source of target information, millimeter wave radar has become particularly important in its detection performance. Because of the high cost, poor repeatability and long test period, at present, the target detection performance test of millimeter wave radar mainly adopts the form of target simulator. The target simulator can simulate the position, distance and speed of the target by cooperating with a high-precision turntable or manipulator to complete the calibration test of basic parameters. The traditional radar target simulator uses a single-channel transceiver to simulate a body target as a single reflection point. In conventional road scenes, the proportion of large-scale vehicle targets is very high. Simplifying it into a single point can easily cause the lack of target characteristics, and cannot effectively verify the radar’s ability to recognize large-scale targets. This article provides a way to simulate a target based on an antenna array, which uses a multichannel transceiver system, and a high-speed RF channel switch to complete the continuous variations of the target orientation. Based on the reflection characteristics database of the target at different azimuth angles, there are multiple strong reflection points for a physical target, which can be achieved by combining multiple point targets. After the consideration of economy and final effect, we chose three point targets to synthesize a body target. The synthesized body target can be modified freely in orientation, horizontal posture, distance, and speed. For typical targets such as pedestrians, cars, vans, and bicycles, the target simulation system we proposed can achieve more realistic target reflection characteristics. At the same time, the target simulation system can produce multiple targets which represent multiple traffic participants. The relative motion between them can be applied to reproduce the real traffic scene Therefore, the logic function test of the hardware-in-loop simulation can be carried out for the ADAS system based on millimeter wave radar.