Experimental Study and Modeling of Oxy-Char Combustion in a Pressurized Fluidized Bed Combustor
Lei Pang,Yingjuan Shao,Wenqi Zhong,Hao Liu
DOI: https://doi.org/10.1016/j.cej.2021.129356
IF: 15.1
2021-01-01
Chemical Engineering Journal
Abstract:Pressurized oxy-coal combustion has received wide attention recently due to its potential of high efficiency and low cost in CO2 capture. However, there is still a significant knowledge gap on the effects of pressure on the oxycoal and oxy-char combustion behaviors. In this study, oxy-char combustion experiments were carried out in a pressurized fluidized bed combustor, and the effects of pressure and oxygen concentration on the burnout time, reactivity and temperature of the char particles were investigated. The experimental results showed that the burnout time of the char particles decreased significantly with an increase in pressure from 0.1 MPa to 0.5 MPa. Besides, an increase in either the combustion pressure (within the range of 0.1 - 0.5 MPa) or the oxygen concentration (within the range of 10 - 30% O-2 in CO2) led to increases in the reactivity and temperature of the char particles, while the promotional effects of the pressure increase were weaker at the higher pressures. In order to better interpret the experimental results, a combustion model considering reaction kinetics, mass and heat transfer, and energy balance was developed and validated by the experimental results. The model simulation results showed that an increase in pressure would reduce the burnout time of char particles only when the combustion was kinetically controlled or combined kinetic-diffusion controlled. Once the combustion became diffusion-controlled, a further increase in pressure would have an insignificant effect on the char burnout time. Although the values of kinetic constants were different when different kinetic models, the global power-law model and Langmuir-Hinshelwood model, were adopted, the simulation results of the burnout time of the char particle under the pressurized fluidized bed combustion conditions were almost the same since the char combustion was mainly diffusion-controlled. The elevated combustion pressure accelerated both the char combustion rate and the char-CO2 gasification rate, while the carbon consumption ratio by gasification increased with pressure. Moreover, the enhanced gasification reaction had a great impact on the particle temperature especially under the higher oxygen concentration combustion conditions.