Abstract:We recently demonstrated that pseudoelastic NiTi tubes compressed axially buckle first into an axisymmetric wrinkling mode but subsequently collapse by progressive development of buckle lobes with three circumferential waves. This behavior is governed by the material nonlinearity associated with the austenite to martensite solid-state transformation. On unloading, the material transforms back to austenite, deformation is recovered, and the buckling lobes are erased (Jiang et al., 2016). The problem was simulated numerically using a constitutive model framework for the pseudoelastic behavior of NiTi based on a J2-type nonlinear kinematic hardening model with the back stress represented through a potential. The first generation of the model did not account for the significant tension/compression asymmetry exhibited by the material so the buckling response did not reproduce well the experiments underestimating the dissipated energy. In the present work the constitutive model is extended to include the tension/compression asymmetry. It is introduced through a weighted mix of two potentials that are calibrated to the tensile and compressive stress-strain responses of the material. In addition, the present model allows for plastic deformations at the completion of martensite transformation. Incorporation of the tension/compression asymmetry significantly improves the calculated response of the buckling and recovery of NiTi tubes both qualitatively and quantitatively. The addition of plastic deformations to the model further improves the predictions. The initial axisymmetric wrinkling and the switch to the buckling mode with three circumferential waves are now reproduced correctly, and so are the evolution of localized collapse and the recovery of deformation on unloading. Furthermore, the stress levels during collapse and recovery follow the experimental levels quite closely thus reproducing the energy dissipated.

Experimental and Numerical Investigation of Bulging Behaviour of Hyperelastic Textured Tubes

An Experimental Study of Localized Bulging in Inflated Cylindrical Tubes Guided by Newly Emerged Analytical Results

Inelastic Effects in Bulge Formation of Inflated Polymer Tubes

Inflation of Stressed Cylindrical Tubes: an Experimental Study

Theoretical Analysis of Inflated Tube Wrinkling Behavior under Pure Bending

Further Assessment of the Plastic Instability of Thin-Walled Tubes in Double-Sided Hydro-Bulging Process with Verification Experiments

Study of Collapsed Deformation and Energy Absorption of Polymeric Origami-Based Tubes with Viscoelasticity

Experimental Study on the Interaction Between Inner Air and Enveloping Membrane of Inflated Membrane Tubes

Localized Bulging of an Inflated Rubber Tube with Fixed Ends

Elastomeric tubes with self-regulated distension

Experimental and numerical analysis of bending behaviors of an inflated boom

Analytical Model for Tube Hydro-Bulging Test, Part I: Models for Stress Components and Bulging Zone Profile

Plastically Deformed Tubes Subjected to Mechanical Expansion Processes

Elastic Buckling Shape Control of Thin-Walled Cylinder Using Pre-Embedded Curved-Crease Origami Patterns

Imperfection Insensitivity of Origami-Inspired Tubular Structures

The cross-sectional geometry regulated Poynting effect in ribbed silicone rubber tubes

Buckling and Collapse of Pseudoelastic NiTi Tubes under Bending

Buckling and Recovery of Niti Tubes under Axial Compression

Behaviour of expansion tubes under impact load: Deformation mode and mechanical response

Three-dimensional postbuckling analysis of thick hyperelastic tubes

Localised bulging of an inflated rubber tube with fixed ends