Abstract:Liquid water within the cathode Gas Diffusion Layer (GDL) and Gas Channel (GC) of Proton Exchange Membrane Fuel Cells (PEMFCs) is strongly coupled to gas transport properties, thereby affecting the electrochemical conversion rates. In this study, the GDL and GC regions are utilized as the simulation domain, which differs from previous studies that only focused on any one of them. A Volume of Fluid (VOF) method is adopted to numerically investigate the two-phase flow (gas and liquid) behavior, e.g., water transport pattern evolution, water coverage ratio as well as local and total water saturation. To obtain GDL geometries, an in-house geometry-based method is developed for GDL reconstruction. Furthermore, to study the effect of GDL carbon fiber diameter, the same procedure is used to reconstruct three GDL structures by varying the carbon fiber diameter but keeping the porosity and geometric dimensions constant. The wall wettability is introduced with static contact angles at carbon fiber surfaces and channel walls. The results show that the GDL fiber microstructure has a significant impact on the two-phase flow patterns in the cathode field. Different stages of two-phase flow pattern evolution in both cathode domains are observed. The liquid water in the GDL experiences water invasion, spreading, and rising, followed by the droplet breakthrough in the GDL/GC interface. In the GC, the water droplets randomly experience accumulation, combination, attachment, and detachment. Due to the difference in surface wettability, the water coverage of the GDL/GC interface is smaller than that of the channel side and top walls. It is also found that the water saturation inside the GDL stabilizes after the water breakthrough, while local water saturation at the interface keeps irregular oscillations. Last but not the least, a water saturation balance requirement between the GDL and GC is observed. In terms of varying fiber diameter, a larger fiber diameter would result in less water saturation in the GDL but more water in the GC, in addition to faster water movement throughout the total domain.

Design of a Multi-Channel Gas Sampling System for Fuel Cell with Dead-Ended Anode Configuration

Designing and multi-evaluation of a promising gas-emission anode for eliminating CO 2 accumulation in microfluidic fuel cell

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

In-situ Characterization of Gas Distribution in Proton Exchange Membrane Fuel Cell Stacks

Numerical simulation of two-phase flow in a multi-gas channel of a proton exchange membrane fuel cell

Simultaneous measurement of local current and temperature distributions in proton exchange membrane fuel cells with dead-ended anode

Experimental Investigation on the Anode Flow Field Design for an Air-Cooled Open-Cathode Proton Exchange Membrane Fuel Cell

An Evaluation Method of Gas Distribution Quality in Dynamic Process of Proton Exchange Membrane Fuel Cell

Design of a Fuel Cell Test System with Fault Identification

Numerical Simulation of Multi-Channel Planar Solid Oxide Fuel Cell Unit by Integrating Continuum Micro-Scale Pen Sub-Model

Dynamic two-phase flow behaviors in permeable network integrated with microchannel

Numerical study on water transfer characteristics under joint effect of placement orientation and flow channel size for PEMFC with dead-ended anode

In-situ Analysis of Anode Atmosphere in a Flat-Tube Solid Oxide Fuel Cell Operated with Dry Reforming of Methane

Numerical simulation of two-phase flow in gas diffusion layer and gas channel of proton exchange membrane fuel cells

Numerical simulation on purge strategy of proton exchange membrane fuel cell with dead-ended anode

Optimizing fuel transport and distribution in gradient channel anode of solid oxide fuel cell

Analysis of Proton Exchange Membrane Fuel Cell reactant gas dynamic response and distribution quality

Model-based estimation of liquid saturation in cathode gas diffusion layer and current density difference under proton exchange membrane fuel cell flooding

Dynamic Test and Real-time Control Platform of Anode Recirculation for PEM Fuel Cell Systems

Design of multi-component gas measurement system based on STM32

A Vehicular Proton Exchange Membrane Fuel Cell System Co-Simulation Modeling Method Based on the Stack Internal Distribution Parameters Monitoring