Abstract:In this work, an adaptive generalized cross-correlation (AGCC) method is proposed that focuses on the problem of the conventional cross-correlation method not effectively realizing the time delay estimation of signals with strong periodicity. With the proposed method, the periodicity of signals is judged and the center frequencies of the strongly periodical components are determined through the spectral analysis of the input signals. Band-stop filters that are used to suppress the strongly periodical components are designed and the mutual power spectral density of the input signals that is processed by the band-stop filters is calculated. Then, the cross-correlation function that is processed is the inverse Fourier transform of the mutual power spectral density. Finally, the time delay is estimated by seeking the peak position of the processed cross-correlation function. Simulation experiments and practical velocity measurement experiments were carried out to verify the effectiveness of the proposed AGCC method. The experimental results showed that the new AGCC method could effectively realize the time delay estimation of signals with strong periodicity. In the simulation experiments, the new method could realize the effective time delay estimation of signals with strong periodicity when the energy ratio of the strongly periodical component to the aperiodic component was under 150. Meanwhile, the cross-correlation method and other generalized cross-correlation methods fail in time delay estimation when the energy ratio is higher than 30. In the practical experiments, the velocity measurement of slug flow with strong periodicity was implemented in small channels with inner diameters of 2.0 mm, 2.5 mm and 3.0 mm. With the proposed method, the relative errors of the velocity measurement were less than 4.50%.

A Time-Varying Signal Processing Method for Coriolis Mass Flowmeter Based on Adaptive Filter.

An Online Determination of Natural Frequency for Coriolis Mass Flowmeter Tube

Analytical calculation of sensitivity for Coriolis mass flowmeter

Research and Implementation of Amplitude Ratio Calculating System for Coriolis Mass Flowmeter

Novel coriolis mass flowmeter signal processing algorithms based on DFT and digital correlation

A Phase Difference Measurement Method Based on Strong Tracking Filter for Coriolis Mass Flowmeter.

Multiple Adaptive Notch Filters Based A Time-Varying Frequency Tracking Method for Coriolis Mass Flowmeter

Complex Signal Processing for Coriolis Mass Flow Metering in Two-Phase Flow

Signal Analysis and Processing of Coriolis Mass Flowmeter

Research on Noise Reduction Technology of Coriolis Mass Flowmeter Based on Wavelet Transform

Signal Processing for Coriolis Mass Flowmeter Based on Hilbert Transform

A Phase Difference Measurement Method Based on the Extended Kalman Filter for Coriolis Mass Flowmeters

Correlation theory-based signal processing method for CMF signals

Coriolis Mass Flowmeter Signal Processing System Based on FFT and Close-Loop Sampling Control

Time Difference Detection Based on Sliding Window All-Phase FFT and Kalman Filtering for Precise Flow Measurement

The Novel Method of Phase Difference Detection in Coriolis Mass Flowmeter

Experimental Study on Dynamic Performance of Coriolis Mass Flow Meter and Compensation Technology

A dynamic performance improvement method of Coriolis Mass Flowmeters

A New Adaptive GCC Method and Its Application to Slug Flow Velocity Measurement in Small Channels

Error Analysis and Accuracy Calibration Method of U-Tube Coriolis Mass Flowmeter Under Pulsating Flow

Experimental Study and Implementation of a Novel Digital Closed-Loop Control System for Coriolis Mass Flowmeter