Abstract:Deformation twinning is an essential plastic deformation mechanism that realizes the trade–off between strength and ductility. Twins nucleate and grow by the coordinated slip of partial dislocations on consecutive {111}–type slip planes. The route of twin growth is responsible for the evolution of twin morphology, which affects the non–coplanar dislocation slips by adjusting the twinning–associated mean free path. Incorporating such twinning mechanisms is critical for the accurate modelling and simulation of deformation behavior. In this study, a discrete dislocation plasticity (DDP) model was developed by integrating the source introduction methods and source activation criteria of Shockley partial dislocation. In the model, two twin nucleation mechanisms, i.e., the internal source and surface source, were considered concurrently, and the additional effect of stacking fault energy on the motion of partial dislocations was introduced. The evolution of partial dislocation slip–mediated deformation twins in micron–sized pillars of twinning–induced plasticity steel under uniaxial compression was investigated. The predicted twin morphologies and stress–strain curves from DDP simulation both agreed well with the experimental results, highlighting the inherent characteristics of partial–dislocation–based twinning behavior. The simulation results showed that the formation of nanometer–sized sharp twin tips was caused by the strong interaction between the front and rear dislocations on adjacent slip planes. In addition, a novel analytical model verified with the DDP simulation was proposed by considering the kinetics of the newly formed twin embryos. The competition between new twin activation and near–twin merging in determining the evolution of twin thickness was analyzed using the analytical model. The dependence of flow stress and twin morphology on the density and distribution of internal sources was demonstrated by considering the new twinning route. This research thus advances the understanding of partial dislocation slip–mediated twinning mechanisms.

Alternative Transmission Mode and Long Stacking Fault Formation During A Dissociated Screw Dislocation Across A Coherent Sliding Interface

Shearing Mechanisms of Stacking Fault and Anti-Phase-boundary Forming Dislocation Pairs in the Γ′ Phase in Ni-based Single Crystal Superalloy

Phase Field Modeling of A Glide Dislocation Transmission Across A Coherent Sliding Interface

Local Lattice Distortion Mediated Formation of Stacking Faults in Mg Alloys

Stress Effects on Interaction Modes and Cross-Slip Annihilation Distance of Screw Dislocation Interactions

Concurrent Interface Shearing and Dislocation Core Change on the Glide Dislocation-Interface Interactions: a Phase Field Approach

Exploring the relation between transonic dislocation glide and stacking fault width in FCC metals

New Insights on Stacking Fault Behavior in Twin Induced Plasticity from Meta-Atom Molecular Dynamics Simulations

Molecular-dynamics simulations of stacking-fault-induced dislocation annihilation in pre-strained ultrathin single-crystalline copper films

An atomistic-to-microscale computational analysis of the dislocation pileup-induced local stresses near an interface in plastically deformed two-phase materials

Undulating Slip In Laves Phase And Implications For Deformation In Brittle Materials

Interface Dislocation Trajectory and Long-Range Strain Associated with the Migration of Semicoherent Interfaces

Evolution of partial dislocation slip–mediated deformation twins in single crystals: a discrete dislocation plasticity model and an analytical approach

Evident α/γ Interface Sliding in Fully Lamellar TiAl Alloy During Hot Deformation: Metallurgical Observation and Mesoscopic Modelling

An investigation of slip transmission during uniaxial tensile deformation of a coarse-grained copper via EBSD characterization and crystal plasticity modelling

A computational approach towards modelling dislocation transmission across phase boundary

Collapse of stacking fault tetrahedron and dislocation evolution in copper under shock compression

Influence of stacking fault energy on friction of nanotwinned metals

Interfacial Dislocations Dominated Lateral Growth of Long-Period Stacking Ordered Phase in Mg Alloys

Mechanical behavior and microstructure evolution of Al/AlCu alloy interface

Ridge-twin Boundaries As Prolific Dislocation Sources in Low Stacking-Fault Energy Metals and Alloys