Poly(3,4-ethylenedioxythiophene) Nanorods/graphene Oxide Nanocomposite As a New Electrode Material for the Selective Electrochemical Detection of Mercury (II)

Yinxiu Zuo,Jingkun Xu,Xiaofei Zhu,Xuemin Duan,Limin Lu,Yansha Gao,Huakun Xing,Taotao Yang,Guo Ye,Yongfang Yu
DOI: https://doi.org/10.1016/j.synthmet.2016.05.022
IF: 4
2016-01-01
Synthetic Metals
Abstract:Development of selective methods for the detection of mercury (Hg2+) has received tremendous attention in modern chemical research due to its health hazard and persistence in environment. In this paper, the electrochemical determination of Hg2+ at trace level based on poly(3,4-ethylenedioxythiophene) nanorods/graphene oxide nanocomposite modified glassy carbon electrode (PEDOT/GO/GCE) is reported. PEDOT/GO nanocomposite has been proposed via a simple liquid-liquid interfacial polymerization approach. Scanning electron microscopy (SEM) and transmission electron microscope (TEM) were employed to characterize the morphology-and structure of the as-prepared PEDOT/GO. The results revealed that PEDOT with a nanorods-like structure anchored on the surface of GO nanosheets, which could enhance the electro-active sites of the nanocomposite. Differential. pulse stripping voltammetry (DPSV) was applied to determine low concentrations of He on PEDOT/GO/GCE. Experimental conditions, including accumulation time, pH values and deposition potential were optimized. In optimal conditions, a good linear relationship was found between peak currents and the concentration of Hg2+ in 10.0 nM-3.0 mu M range. The detection limit was estimated to be 2.78 nM at a signal-to-noise ratio of 3. Finally, the applicability for Hg2+ determination in tap water samples was successfully demonstrated. (C) 2016 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?