Abstract:The investigation of frictional pressure drops in wire-wrapped bundles at low flow velocities is crucial for thermal-hydraulic studies of sodium-cooled fast reactor cores. This study aims to refine empirical formulas for predicting friction factors in wire-wrapped bundles by addressing their limitations in accurately calculating friction factors during transition regime. By analyzing existing empirical formulas and meticulously observing frictional pressure drop experiments conducted under low-flow conditions that reported in the literature, the study proposes and demonstrates the mechanism of the laminar-to-transitional regime transition in wire-wrapped bundles. Additionally, experimental research was conducted on the frictional pressure drop of a 37-rod wire-wrapped bundle. A novel high-precision differential pressure measurement technique, the photographic liquid column manometer, was employed to enhance frictional pressure drop measurement accuracy. This innovative method achieves a measurement uncertainty of less than 2 Pa within a range of 0 to 300 Pa. The mass flow rate of the fluid was measured and converted to obtain the flow velocity through the assembly, further improving the accuracy of flow velocity measurements. The analysis and experiments reveal that the transition from the laminar to transitional regime does not occur uniformly but initiates locally in certain subchannels before spreading across the assembly as flow velocity increases. Significant increases in the frictional pressure drop occur only after a sufficient number of subchannels have undergone transition. This perspective is supported by extensive existing literature, which report that in assemblies with fewer rod bundles, smaller P/D and H/D values, and constructed from hard metal materials such as stainless steel, the friction factor at the initial stage of the transitional regime shows a significant increase or remains constant with increasing Reynolds number. Under these conditions, the high consistency of the P/D ratio within the assembly causes the fluid to transition within a narrow range of flow velocities, leading to a marked increase in the friction factor with Reynolds number. The research results also indicate that the prediction accuracy of the critical Reynolds number for the laminar-to-transitional flow transition significantly impacts the calculation accuracy of empirical formulas at low flow velocities. Formulas using smaller predicted values of the critical Reynolds number show better agreement between predicted values and the measured results in this study. Therefore, the study recommends adopting smaller critical Reynolds numbers and interpolation indices in empirical formulas to facilitate an early onset and smooth transition of laminar-to-transitional regime behavior in friction factors, thereby improving the accuracy of calculated friction factors.

Pressure Drop Characteristics of Vertically Upward Flow in Inclined Rod Bundles

Experimental Research on Fluid-Elastic Instability in Tube Bundles Subjected to Air-Water Cross Flow

Experimental Study of the Effect of Inclination Angle on the Minimum Conveying Velocity and the Underlying Mechanisms

Dynamic Pressure Drop Property of Gas-Liquid Two-Phase Flow around a Horizontal Cylinder

Friction pressure drop model of gas-liquid two-phase flow in an inclined pipe with high gas and liquid velocities

Frictional pressure drop of two-phase flow in a horizontal tube under low void fraction

Experimental Investigation on Air-Water Two-Phase Flow Pattern and Pressure Drop in Vertical Upward Annulus

Experimental investigation on spatial phase distributions for various flow patterns and frictional pressure drop characteristics of gas liquid two-phase flow in a horizontal helically coiled rectangular tube

Flow characteristics of dispersed two-phase flows in an 8 × 8 rod bundle

Relationship between fluctuating differential pressure and void fraction of gas-liquid two-phase flow in Venturi tube

Pressure Drop Characteristics of Vertical Dilute-phase Gas Conveying

Experimental investigations of gas–liquid two-phase flow in a horizontal mini pipe: Flow regime, void friction, and frictional pressure drops

Experimental Study on Gas-Liquid Two-Phase Stratified Flow at High Pressure in a Horizontal Pipe

Experimental Investigation and Analysis on the Cross Flow Characteristics over Inline Tube Bundles with S/D=1.875

Flow Pattern Study and Pressure Drop Prediction of Two-Phase Boiling Process in Different Surface Wettability Microchannel

Evaluation of Two-Phase Frictional Pressure Drop Correlations Against Experimental Data

A numerical investigation on single-phase flow characteristics and frictional pressure drop in helical pipes

Experimental Study on Frictional Pressure Drop Characteristics of Wire-wrapped Bundles in Transition Flow

Experimental Investigation of the Subchannel Axial Pressure Drop and Hydraulic Characteristics of a 61-Pin Wire Wrapped Rod Bundle

Experimentally Investigating Phase Separation and Pressure Drop As Bubbly Flow in a Vertical Branching T-junction

A New General Correlation for Frictional Pressure Drop During Condensation Inside Horizontal Micro-Fin Tubes