Abstract:With the increasing demand for higher quality and performance of equipment and assembly in aerospace, shipbuilding, medical and other fields, the machining accuracy of parts is facing higher requirements. It is particularly important to predict the cutting force accurately, which is the main physical quantity in the machining process and basis of process inspection and quality control. In this paper, the cutting force model in five-axis milling with fillet-end cutter is proposed, which reveals the law of force–deflection coupling. Firstly, the initial cutter deflection model induced by the ideal cutting force ignoring the effect of deflection is built based on analysis of the geometric characteristics of fillet-end cutter. Then, the undeformed chip thickness model is educed considering the cutter posture and cutter deflection. Further, the iterative method is utilized to resolve the coupling relationship between cutter deflection and cutting force. Finally, the cutting force model under force–deflection coupling is established for achieving more accurate prediction. To verify the effectiveness of the proposed cutting force model, the milling experiment is carried out on a five-axis milling center. The measured cutting force values are utilized to inspect the accuracy of prediction models considering and not considering force–deflection coupling, respectively. The results show that the proposed method could improve the prediction accuracy of cutting force, which show the effectiveness of taking force–deflection coupling law into consideration clearly. The influence of cutter posture on cutting force is analyzed using the proposed cutting force model. The cutting force decreases with the increase in lead angle or tilt angle, and the influence of tilt angle is greater than that of lead angle under experimental conditions of five-axis milling using the set process parameters.

Mechanistic Modeling of Five-Axis Machining with a Flat End Mill Considering Bottom Edge Cutting Effect

Mechanistic Modeling of Five-Axis Machining with a General End Mill Considering Cutter Runout

Prediction of Cutting Force in Five-Axis Flat-End Milling

Cutting Force Modeling for Flat End Milling Including Bottom Edge Cutting Effect

An Approach to Modeling Cutting Forces in Five-Axis Ball-End Milling of Curved Geometries Based on Tool Motion Analysis

Cutting Edge Element Modeling-Based Cutter-Workpiece Engagement Determination and Cutting Force Prediction in Five-Axis Milling

A New Approach of Modelling Bottom Edge Cutting in 4-Axis Rough Milling of Complex Parts and Its Application on Feed Rate Optimization

Enhanced modeling of instantaneous uncut chip thickness and cutter workpiece engagement region in 5 axis ball end milling: Case of the tilt orientation

An Identification Model of Cutting Force Coefficients for Five-Axis Ball-End Milling

Study of the Classification of Cutting Forces and the Build of Accurate Milling Force Model in End Milling

A new ternary-mechanism model for the prediction of cutting forces in flat end milling

Milling Force Prediction Model for Five-Axis Machining of Freeform Surface Considering Mesoscopic Size Effect

Mechanistic Modeling Considering Bottom Edge Cutting Effect and Material Anisotropy During End Milling of Aluminum Honeycomb Core

Mechanistic modeling considering the bottom edge cutting effect and the material anisotropy during end milling of the aluminum honeycomb core

Decoupled Chip Thickness Calculation Model for Cutting Force Prediction in Five-Axis Ball-End Milling

Prediction of Cutting Forces in Flank Milling of Parts with Non-Developable Ruled Surfaces

Cutting force prediction considering force–deflection coupling in five-axis milling with fillet-end cutter

A Cutting Force Model Based on Compensated Chip Thickness in Five-Axis Flank Milling

Tool Orientation Optimization of 5-Axis Ball-End Milling Based on an Accurate Cutter/workpiece Engagement Model

Modeling and analysis for virtual fiveaxis flank milling process

Parametric Chip Thickness Model Based Cutting Forces Estimation Considering Cutter Runout of Five-Axis General End Milling