Limestone Decomposition in an O2/CO2/Steam Atmosphere Integrated with Coal Combustion

Zehua Li,Yin Wang,Zhiwei Li,Meng Li,Kai Xu,Wenqiang Liu,Guangqian Luo,Hong Yao
DOI: https://doi.org/10.1021/acs.energyfuels.6b00610
IF: 4.6541
2016-01-01
Energy & Fuels
Abstract:Ca looping is one of the most promising technologies for CO2 capture. Calcined limestone can be used in the Ca looping system. It is a low-cost approach to decompose limestone integrated with coal combustion in an O-2/CO2/steam atmosphere. In this approach, coal combustion heat is continuously supplied for limestone decomposition. We aim to obtain high-purity CO2 exhaust gas and high-reactivity CaO sorbent. High-purity CO2 exhaust gas is then further compressed or used. High-reactivity sorbent is then used to capture CO2 from the coal power plant. However, little research was found to investigate limestone decomposition behavior under oxy-steam combustion conditions. In this study, limestone and coal particles were mixed together and decomposed/combusted in a continuously operating fluidized bed reactor in an O-2/CO2/steam atmosphere. The results show that increasing O-2 and steam supply reduces the emission of CO, H-2, and SO2, which enhances the purity of CO2 exhaust gas. Limestone decomposition conversion is also enhanced with the increase of O-2 and steam supply. Besides, most coal sulfur and ash react with small CaO sorbent particles, which flow out of the reactor and remain in the, cyclone. The amount of coal sulfur and ash is very low in a large CaO sorbent particle and has little influence on sorbent reactivity. In situ coal combustion results in a high particle temperature and high limestone decomposition conversion in the fluidized bed but also results in sorbent sintering and a sorbent reactivity decrease. Fortunately, sorbent reactivity is improved by introducing steam into limestone decomposition and a coal combustion atmosphere.
What problem does this paper attempt to address?