Abstract:Supercapacitors are gaining increasing attention for complementing or replacing batteries and they are highly desirable in applications where high power and long cycle life of energy storage devices are needed. Activated carbons (AC) are the most promising electrodes in the supercapacitor industry presenting the best performances/cost compromise. Recently, graphene, with a two dimensional carbon nanostructure, has emerged as a new class of promising electrode material in supercapacitors, due to its outstanding properties such as high electric conductivity, high surface area, good mechanical properties and chemical inertia. Among the various approaches to producing graphene materials, here we focus on reduced exfoliated graphene oxide (r-GO) derived from chemically synthesised graphene oxide (GO). However, the graphene materials prepared by either chemical or thermal reduction of the graphene oxide always exhibits a relatively low electrochemical performance due to the agglomeration of graphene sheets and does not reflect the intrinsic capacitance of an individual graphene nano-sheet. To exploit the potential electrochemical applications for graphene, a particularly attractive option is to design and develop composites of graphene with other materials. In this study, we present an approach to synthesize a composite of reduced graphene oxide (r-GO) with activated carbon and its use as an electrode material in supercapacitors. To the best of our knowledge, a few studies on the preparation of GO/AC composites have been reported so far. Graphene oxide was synthesised using vein graphite by a modified Hummers method and then mixed with activated carbon to prepare a homogeneous composite. The composite was thermally reduced to convert GO in to r-GO. The morphology and chemical structure of the materials were characterized by means of Electron microscopy, Raman spectroscopy, X-ray diffraction and Fourier Transform Infrared Spectroscopy. Thermal properties were investigated using Thermo Gravimetric Analysis. The electrochemical properties of as obtained composites with different mass ratios were investigated, together with their individual components (GO, r-GO and AC) for comparison. For electrochemical characterisation, two-electrode symmetrical supercapacitor cells were constructed and characterized by cyclic voltammetry and electrochemical impedance spectroscopy. Tetraethylammonium tetrafluoroborate (TEABF4) in Propylene Carbonate (PC) was used as the electrolyte. The CV curves were measured from 0 to 1 V with various scan rates ranging from 10 to 1000 mV s −1 and the CV data were used to calculate the specific capacitances of the electrodes. The results showed that the as-prepared composites exhibited an improved electrochemical performance as compared to pure r-GO or AC. This improvement can be attributed to the synergistic effect of AC and r-GO. The maximum specific capacitance observed for the r-GO/ AC composite was 115.6 F/g at a scan rate of 10 mV s -1 . The near-rectangular CV curves at ultrafast sweep rate of 1000 mV s -1 indicated very efficient charge transfer within the composite electrodes. The incorporation of rGO into AC, not only provides the vacancies to accommodate ions, but also forms a promising network structure to conductively bridge the spaces between the AC particles, which can facilitate rapid transport of the electrolyte ions within the electrode materials, leading to a high-rate performance of the supercapacitor. Within the composite, r-GO plays the role of both the binder and the conductive additive increasing the specific capacitance and the power density of the devices.

Self-assembled Reduced Graphene Hydrogels by Facile Chemical Reduction Using Acetaldehyde Oxime for Electrode Materials in Supercapacitors

Graphene Aerogel Derived by Purification-Free Graphite Oxide for High Performance Supercapacitor Electrodes

Dimethylsulfoxide-Dependent Environments for Fabricating Graphene Hydrogels for High-Performance Supercapacitor.

High-Performance Self-Assembled Graphene Hydrogels Prepared by Chemical Reduction of Graphene Oxide

Three Dimensional Nitrogen-Doped and Nitrogen, Sulfur-Codoped Graphene Hydrogels for Electrode Materials in Supercapacitors

Graphene Oxide and Activated Carbon Composites for High-Power Supercapacitors

Synergistic Effect of Fe3O4/reduced Graphene Oxide Nanocomposites for Supercapacitors with Good Cycling Life

Facile one-step hydrothermal synthesis of reduced graphene oxide/Co3O4 composites for supercapacitors

Reduced Graphene Oxide as a Monolithic Multifunctional Conductive Binder for Activated Carbon Supercapacitors

Reduced Graphene Oxide Hydrogel for High Energy Density Symmetric Supercapacitor with High Operation Potential in Aqueous Electrolyte

High-performance Supercapacitors Based on the Reduced Graphene Oxide Hydrogels Modified by Trace Amounts of Benzenediols

Preparing electrodes with highly reduced graphene oxide load for supercapacitors by dropping-electrochemical reduction

Facile Synthesis of Porous Graphene As Binder-Free Electrode for Supercapacitor Application

Facile synthesis of 3D reduced graphene oxide and its polyaniline composite for super capacitor application

Uv-Assisted Reduction of Graphene Oxide on Ni Foam As High Performance Electrode for Supercapacitors

Fabrication of 3D MXene@graphene hydrogel with high ion accessibility via Al-induced self-assembly and reduction for high-performance supercapacitors

Interfacial engineering of reduced graphene oxide for high-performance supercapacitor materials

Tuning the Surface Chemical State of Graphene Oxide Sheets for the Self‐Assembly of Graphene Hydrogel for Capacitive Energy Storage

One-Step Synthesis of Fragment-Reduced Graphene Oxide as an Electrode Material for Supercapacitors

Three-Dimensional Graphene-Based Composite Hydrogel Materials for Flexible Supercapacitor Electrodes

Synthesis of reduced graphene oxide supported nickel-cobalt-layered double hydroxide nanosheets for supercapacitors