Abstract:The power density of electronic components grows continuously, and the subsequent heat accumulation and temperature increase inevitably affect electronic equipment's stability, reliability and service life. Therefore, achieving efficient cooling in limited space has become a key problem in updating electronic devices with high performance and high integration. Two-phase immersion is a novel cooling method. The computational fluid dynamics (CFD) method is used to investigate the cooling performance of two-phase immersion cooling on high -power electronics. The two-dimensional CFD model is utilized by the volume of fluid (VOF) method and Reynolds Stress Model. Lee's model was employed to calculate the phase change rate. The heat transfer coefficient along the heated walls and the shear-lift force on bubbles are calculated. The simulation data are verified with the literature results. The cooling performance of different coolants has been studied. The results indicate that the boiling heat transfer coefficient can be enhanced by using a low boiling point coolant. The methanol is used as the cooling medium for further research. In addition, the mass flow rate and inlet temperature are investigated to assess the thermal performance of twophase immersion cooling. The average temperature of the high -power electronics is 80 degrees C, and the temperature difference can be constrained to 8 degrees C. Meanwhile, the convective heat transfer coefficient reaches 2740 W/(m2 center dot degrees C) when the inlet temperature is 50 degrees C, and the mass flow rate is 0.3 kg/s. In conclusion, the results demonstrated that two-phase immersion cooling has provided an effective method for the thermal management of high -power electronics.

Simulation and Optimization of Cooling System for 2kw Accelerator

Numeric Al Simulation and Optimization of Cooling System for 2 M Accelerating Tube

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Analytical Modeling of Forced-Air Cooling Heatsink by Considering Air Temperature Rise in Channel and Coupling of Multiple Heat Sources

Design And Simulation Of A Cooling System For The High Current 4-Rod Rfq Cavity

Device Design and Simulation Optimization of Exhaust Gas Cooling

Optimization of Cooling System of Linac Collinear Load

Heat Transfer Simulation and Analysis of Electron Collector Based on Real-time Uniformity Detection Device of Irradiation Accelerator

Design and Simulation of a 1.2mev Electron Accelerator Used for Desulfuration and Denitrogenation

Design and Analysis of Cooling Water System for ECRH and ICRF Testing Bench

Simulation design and power distribution calculations of linac collinear load based on Kanthal alloy

Simulation-guided design of a target-cooling system for cyclotron-based isotope production

Numerical Simulation and Design of Cooling System for Low-Power Accelerating Tube

An Numerical Investigation on the Cooling Capacity of Needle-Ring Type Electrostatic Fluid Accelerators for Round Plate with Uniform and Non-Uniform Heat Flux

Verification of the Design of Sub-critical Device for Accelerator Driven System

Digital Design for Structure of Cathode/grid Assemblies in Electron Curtain Accelerator

Optimization and Evaluation of a High-Performance Liquid Metal CPU Cooling Product

Designing the cooling System of the New B1 Buncher

Optimization of EAST ICRH antenna Faraday shield cooled structure

COOLING DESIGN FOR THE FRIB RFQ CAVITY AT MICHIGAN STATE UNIVERSITY

Numerical Investigation on Thermal Performance of Two-Phase Immersion Cooling Method for High-Power Electronics