Abstract:OBJECTIVE:To investigate the changes of the vertical height and width of the alveolar bone six months after the alveolar ridge preservation in periodontal compromised molar sites of severe alveolar bone defects with clinical direct measurement, parallel periapical radiographs, and cone-beam computed tomography (CBCT), and to analyze the effect of the three different methods of measurement. METHODS:In this study, 20 subjects requiring tooth extraction on account of periodontal disease with a total of 23 extracted molars were enrolled. Extractions were performed atraumatically and patients were received alveolar ridge preservation procedure with Bio-Oss and Bio-Gide. Clinical direct measurements were taken after tooth extraction and during the implant surgery 6 months later, CBCT scans and parallel periapical radiographs were taken immediately after ridge preservation and 6 months later. The changes of alveolar ridge width and vertical height after six months were measured and analyzed through the above-mentioned three methods and the similarities and differences of the measured effect were compared. RESULTS:There were no significant difference of alveolar vertical height in the center of the extraction sites, the center of distal aspect, and distobuccal aspect between the clinical direct measurements and the CBCT measurements (P>0.05), alveolar vertical height in other points and alveolar width measurements were statically significant (P<0.05). After 6 months, 10 sites of 10 subjects were received a flap and re-entered to perform dental implants surgery. The vertical height in the center of alveolar increased significantly and the changes of alveolar vertical height of clinical direct and CBCT measurement were (6.15 ± 1.73) mm and (6.59 ± 2.53) mm, respectively. The measurements of the width of the alveolar bone were (8.45 ± 1.18) mm and (8.52 ± 1.27) mm, respectively. The measurements of the two methods were not statistically significant (P>0.05). The change of the alveolar height in the center of the extraction socket after six months measured by parallel periapical was (5.84 ± 4.28) mm, which was closed to the clinical direct measurement and the CBCT measurement. CONCLUSION:Clinical direct measurement and CBCT measurement were largely consistent in the evaluation of the alveolar bone height and width after the alveolar ridge preservation using deproteinized boving bone mineral (DBBM, Bio-Oss) and bioabsorbable collagen membrane (Bio-Gide) in periodontal compromised molar sites of severe bone defects.

Study of Alveolar Ridge Augment of Modified Sandwich Techniques Retained by Implants Upon Dogs

Alveolar ridge dimensional changes following ridge preservation procedure using SocketKAP(™) : exploratory study of serial cone-beam computed tomography and histologic analysis in canine model

Hard and soft tissue changes around implants installed in regular-sized and reduced alveolar bony ridges. An experimental study in dogs

Dynamics Evaluation of Newly Formation Bone in Canine Extraction Socket: A X-ray Micro-Computed Tomography Study

Application of a new composite mineralized collagen membrane in alveolar ridge preservation in dogs

Evaluation of Dental Implants Following Ridge Preservation in Molar Extraction Sockets Affected by Advanced Periodontitis: A 30-Month Postloading Case Series

Alveolar regeneration of the post-extraction site with cortical deficiency using the Lamina Socket Sealing technique: Retrospective study with histomorphometric analysis of regenerated bone and evaluation of soft tissue changes. Part 2/2

Experimental study of immediate submerged root implant. Part 2 Comparative studies of pathological and radiological evaluation.

Alveolar ridge preservation of two‐wall bone defects using mineralized dentin matrix: An experimental pre‐clinical study

Alveolar regeneration of the post-extraction site with cortical deficiency using the Lamina Socket Sealing technique: A retrospective study with clinical, radiographic and histomorphometric analysis. Part 1/2

Influence of preservation of the alveolar ridge on delayed implants after extraction of teeth with different defects in the buccal bone

Bone Healing Process Around Distraction Implants Following Alveolar Distraction Osteogenesis: a Preliminary Experimental Study in Dogs.

[Evaluation with Different Measuring Methods for the Alveolar Bone Change of Ridge Preservation in Molar Sites].

Effects of the bilayer nano-hydroxyapatite/mineralized collagen-guided bone regeneration membrane on site preservation in dogs.

Alveolar ridge dimensional changes following ridge preservation procedure with novel devices: Part 1--CBCT linear analysis in non-human primate model

[A Prospective Cohort Study on the Effect of Implant Restoration Following Micro Crestal Flap-Alveolar Ridge Preservation at Molar Extraction Sockets with Severe Periodontitis].

Clinical Evaluation of Two-Implant-supported Single Molar Restoration

Effectiveness of a collagen matrix seal and xenograft in alveolar ridge preservation: an experimental study in dogs

Histological and Micro-Computed Tomography Analyses

Ridge Alterations following Socket Preservation Using a Collagen Membrane in Dogs

Evaluation of flat ridge rehabilitation using an intraoral custom-made distraction device at four weeks versus eight weeks and its impact on dental implant efficacy: A comparative study