Abstract:The recovery of Au(I) from cyanide leaching solutions by solvent extraction techniques has attracted wide interest in the past decades. However, no substantial progress in industries has been reported yet, because of the difficulties concerning gold stripping from loaded organic phases, such as the quaternary amines extraction systems. In this work, a new technique for the recovery of Au(CN)(2)(-) from the loaded cetyltrimethylammonium bromide / tributyl phosphate organic solution by a two-step stripping procedure is suggested first by Au(CN)(2)(-) conversion by HCl into corresponding chloride complex ions, and then by chemical reduction of auro-chloride complex ions in TBP organic phases to give metal gold powder. The influences of HCl concentrations, reaction time, and various reducing agents used on the percent gold conversion and reduction were investigated. About 33% of Au(CN)(2)(-) in the initial TBP organic phase could be precipitated as metal gold powder in the conversion step, while 67% was converted into AuCl2- or AuCl4- and held in the organic phase. Subsequently, the loaded organic phase after conversion was contacted with reducing agents such as sodium sulfite, ammonium oxalate, or hydrazine hydrate. Most (98%) of the auro-chloride complex ions could be effectively reduced as metal gold. As a result, the total gold recovery from the initial TBP organic phases after the two stripping procedures achieved more than 98%. The 198Au radioactive tracer was employed to determine the concentration and distribution behavior of gold in both organic and aqueous solutions. In addition, the experiment on the reuse of the organic phase after gold stripping showed that there was no obvious loss in percent gold(I) recovery after one cycle of the extraction- stripping- regeneration process no matter what reducing agent was used.

Solvent Extraction of KAu(CN)2 Using Quaternary Ammonium Salt

Solvent extraction and stripping of gold(I) cyanide in the tetradecyldimethylbenzylammonium chloride system

Solvent Extraction of Au(I) from Auro-Cyanide Solution with Cetyltrimethylammonium Bromide/Tri-n-Butyl Phosphate System using Column-Shaped Extraction Equipment

Mechanism of Gold Solvent Extraction from Aurocyanide Solution by Quaternary Amines: Models of Extracting Species Based on Hydrogen Bonding

Solvent Extraction of Cesium with A New Compound Calix[4]Arene-Bis[(4-Methyl-1,2-Phenylene)-Crown-6]

Mechanism of Extraction of Oxalic Acid by Quaternary Ammonium Salt

Investigation on the Extraction Mechanism of Au(I) from Cyanide Solution with Quaternary Ammonium System

Extraction of gold(III) from hydrochloric acid solutions by CTAB/n-heptane/iso-amyl alcohol/Na2SO3 microemulsion

Removal of Cesium by Countercurrent Solvent Extraction with A Calix[4]Crown Derivative

Extraction Equilibrium of Typical Alkali Metals with a Macrocyclic Calixbiscrown Derivative in Two-Phase System HNO3/o-Nitroanisole and HNO3/HCCl3

Stripping of Au(I) from a Loaded Cetyltrimethylammonium Bromide/Tributyl Phosphate Organic Solution: Conversion and Reduction

Extraction equilibrium and thermodynamics of cesium with a new derivative of calix[4]biscrown

Solvent Extraction of Trace Gold(i) in Alkaline Cyanide Solution Using CTAB/TBP System

EXAFS Study on the Stripping Mechanism in N263/Alkaline Cyanide Gold Solution/Sulfuric Thiourea System

Identification of Solvent Extraction of Au(III) by Cyanex 272 from Hydrochloric Acid Solutions

Extraction of Cesium and Some Typical Metals with a Supramolecular Recognition Agent 1,3-Bis(1-nonyloxy)-2,4-crown-6-calix[4]arene

STRIPPING OF GOLD FROM QUATERNARY AMINE EXTRACTION SYSTEMS

The extraction of low-concentrations of gold(I) with 198Au as a radiotracer

The Extraction Of Low-Concentrations Of Gold(I) With Au-198 As A Radiotracer

Abnormal Influence of Salting-out Agent on Au(CN)-2 Solvent Extraction by CTMAB

Solvent Extraction Of Gold From Alkaline Cyanide Solution By Primary Amine N1923