Abstract:Cloud point extraction (CPE) is proposed as a pre-concentration procedure for the determination of Hg in Chinese herbal medicine samples by hydride generation-atomic fluorescence spectrometry (HG-AFS). Hg2+ was reacted with dithizone to form hydrophobic chelate under the condition of pH. Using Triton X-114, as surfactant, chelate was quantitatively extracted into small volume of the surfactant-rich phase by heating the solution in a water bath for 15 min and centrifuging. Four variables including pH, dithizone concentration, Triton X-114 concentration and equilibrium temperature (T) showed the significant effect on extraction efficiency of total Hg evaluated by single-factor experiment, and Box-Behnken design and response surface method- ology were adopted to further investigate the mutual interactions between these variables and to identify their optimal values that would generate maximum extraction efficiency. The results showed that the binomial was used to fit the response to experimental levels of each variable. ALL linear, quadratic terms of four variables, and interactions between pH and Trion X-114, pH and di- thizone affected the response value(extraction efficiency) significantly at 5% level. The optimum extraction conditions were as follows: pH 5.1, Triton X-114 concentration of 1.16 g x L(-1), dithizone concentration of 4.87 mol x L(-1), and T 58.2 degrees C, the predicted value of fluorescence was 4528.74 under the optimum conditions, and the experimental value had only 2.1% difference with it. Under the conditions, fluorescence was linear to mercury concentration in the range of 1-5 microg x L(-1). The limit of detection obtained was 0.01247 microg x L(-1) with the relative standard deviations (R.S.D.) for six replicate determinations of 1.30%. The proposed method was successfully applied to determination of Hg in morindae Radix, Andrographitis and dried tangerine samples with the recoveries of 95.0%-100.0%. Apparently Box-Behnken design combined with response surface analysis method was considered to be well used for optimization of the cloud point extraction.

Determination of Lead and Cadmium in Lycium barbarum L by Graphite Furnace Atomic Absorption Spectrometry with Cloud Point Extraction

Determination of Cadmium, Chromium and Lead in Lycoris Radiata with Microwave Digestion Technique by Graphite Furnace Atomic Absorption Spectrometry

Determination of lycorine and galantamine contents in Lycoris aurea from different altitudes in Xuefeng Mountain by high performance liquid chromatography

Simultaneous determination of trace amount of lead and cadmium in mouse liver after cloud point extraction by GFAAS

Determination of Pb and Cd by Graphite Furnace Atomic Absorption Spectrometry after Preconcentration with Graphene-Titanium Dioxide Composites

Determination of trace copper in water sample by flame atomic absorption spectrometry with cloud point extraction preconcentration

Single drop microextraction combined with graphite furnace atomic absorption spectrometry for determination of lead in biological samples

Rapid, Simultaneous, and Automatic Determination of Lead and Cadmium in Cereals with a New High Performance Composite Hollow Cathode Lamp Coupled to Graphite Furnace Atomic Absorption Spectrometry

Separation, Preconcentration, and Determination of Lead, Cadmium, and Iron Using Cloud Point Extraction with Flame Atomic Absorption Spectrometry

Determination of Organophosphorus Pesticides in Lycium Barbarum by Gas Chromatography with Flame Photometric Detection.

Determination of 19 elements in lycium barbarum by ICP-MS using microwave digestion for sample preparation

SIMULTANEOUS DETERMINATION OF AS AND HG IN Lycium barbarrum L.AND ITS PRODUCTS BY HG-AFS

Determination of Trace Cadmium in Leather Products by Graphite Furnace Atomic Absorption Spectrometry

Cloud Point Extraction for Determination of Mercury in Chinese Herbal Medicine by Hydride Generation Atomic Fluorescence Spectrometry with Optimization Using Box-Behnken Design

QuEChERS Cleanup and Gas Chromatography-Mass Spectrometry Determination of Twelve Pesticide Residues in Lycium Barbarum

Comparative Study on Three Pretreatment Methods for Atomic Absorptive Spectrophotometry Determination of Metal Elements in Lycium Barbarum.

Determination of Taurine in Lycium Barbarum L. and Other Foods by Capillary Electrophoresis with Electrochemical Detection

Determination of trace lead in water samples by continuous flow microextraction combined with graphite furnace atomic absorption spectrometry.

Determination of Lead in Water Samples Using a New Vortex-Assisted, Surfactant-Enhanced Emulsification Liquid–Liquid Microextraction Combined with Graphite Furnace Atomic Absorption Spectrometry

Cloud Point Extraction–thermospray Flame Quartz Furnace Atomic Absorption Spectrometry for Determination of Ultratrace Cadmium in Water and Urine

Organic Solvent-Free Cloud Point Extraction-Like Methodology Using Aggregation of Graphene Oxide.