Preparation of Fe-TiO2 Photocatalytic Coating Material and Characterization of Its Performance of Formaldehyde Degradation Under Visible Irradiation

林劲冬,梁丽云,蓝仁华,陈焕钦
DOI: https://doi.org/10.3321/j.issn:1003-5214.2004.02.010
2004-01-01
Abstract:Fe-TiO_2 photocatalyst was prepared by the method of dipping commercial anatase TiO_2 photocatalyst PC-500 in the acetone solution of Fe~(3+).By adding the Fe-TiO_2 photocatalyst into an oxidation-resistant potassium silicate paint system,a photocatalytic functional coating was obtained.In a self-designed gas-solid phase intermittent photocatalysis reactor,the performance of formaldehyde degradation of the photocatalytic coating under visible irradiation was tested.Experimental results indicated that the coating can degrade formaldehyde at the average rate of 20.3 mg/(m~2·h) in the first 3 hours.A similar degradation rate for formaldehyde can be attained if the coating is refreshed for 24 h in clean air.After artificially accelerated weathering for 480 h,the coating still had an average degradation rate of 16.2 mg/(m~2·h) in 3 hours for formaldehyde degradation.
What problem does this paper attempt to address?