Abstract:Because the distribution networks distribute electric energy to customers, has many equipment, a wide range and complex network structure, various failures are prone to occur. Rapid failure self-healing is the key means to improve the reliability of power supply in distribution network. This paper proposes a method for fast service restoration of out-of-service areas without failures based on peer-to-peer (P2P) communication of intelligent terminals. It uses distributed intelligent terminal units as the algorithm carrier and a P2P communication network composed of loop Ethernet. It can accurately distinguish the normal state and the failure state based on the generalized Kirchhoff Current Law setting and realize the failure location and isolation without the delay setting problem of the three-stage current protection. In order to verify its effectiveness, a 0.4 kV dynamic simulation model was developed, and scenarios including different types of switches and different topologies are established. The experimental results show that, unlike other algorithms, such as building a convex model, then, using various intelligent algorithms to solve it, the proposed method can complete the load transfer more quickly, whether switches are all circuit breakers, or partly circuit breakers and partly load switches. In the former case, service restoration can be completed within 2.4 s, faster than other centralized or distributed methods, even when the failure occurs in the worst point, as is shown in the results of test scenario 1. In addition, in the latter case, service restoration can be achieved at least within 4.2 s.

Custom switching technology to improve reliability and real-time performance of information flow in smart substation

Switch Technology in Intelligent Substation

Integrated Automation of Low Voltage Substation

Study on Communication Service Strategy for Congestion Issue in Smart Substation Communication Network

Cost and delay tradeoff in three-stage switch architecture for data center networks

Switch Cost and Packet Delay Tradeoff in Data Center Networks with Switch Reconfiguration Overhead

Smart substation advanced application software adapted for two level distributed smart dispatch and control

Application Research of Multi-site Smart Substation Based on Digital and Physical Simulation Technology.

Laboratorial Implementation of Future Intelligent Transmission Network Substation for Smart Grid

A Method of Real-Time Data Acquisition and Exchange in Adaptation to Integrated Dispatching Automation System

DESIGN AND IMPLEMENTATION OF NETWORK CODING BASED SWITCHING SYSTEM SIMULATION PLATFORM

The Application of Parallel Redundancy Protocol in Smart Substation Network

Study On Process Level Network Message Transmission Time Of Smart Substation

Modeling and Simulation of Data Flow for VLAN-Based Communication in Substations

A load balancing scheme for two-stage switches with minimum buffers for scalability

Parallel Switch System with QoS Guarantee for Real-Time Traffic

A Wide-area Automatic Switchover System Based on EMS

Design of a Hybrid Switching Architecture for Avionic WDM Platforms

HSR-based Intelligent Substation Process Level Communication Network

Quantitative Assessment of Stochastic Property of Network-Induced Time Delay in Smart Substation Cyber Communications.

Optimal Service Restoration and Adaptive Switching of Tie Switches Method of Distributed Self-healing Control in Distribution Systems