Abstract:An efficient intersection signal scheme is of vital significance to urban traffic operation. At present, multiperiod fixed-timing control is still the traffic signal control method adopted by many urban intersections. For the optimization problem of signal scheme selection at signalized intersections, we proposed three two-step prediction optimization methods that match the traffic arrival in different periods with the corresponding optimal signal scheme, aimed at reducing the total delay of vehicles at signalized intersections. The first method predicts the traffic flow in each entrance direction of the intersection by minimizing the mean square error (MSE), then obtains the total vehicle delay of each scheme in the signal scheme set through the Highway Capacity Manual 2010 delay formula, and finally substitutes it into the signal optimization model to obtain the optimal scheme combination. The second method directly predicts the total vehicle delay at intersections of all signal schemes by minimizing the MSE and then substitutes it into the signal optimization model to obtain the optimal scheme combination. The third method directly predicts the total vehicle delay at intersections of all signal schemes by minimizing both the MSE and the prediction error between every two schemes and then substitutes it into the signal optimization model to obtain the optimal scheme combination. Verification based on actual intersection shows that better optimization results can be obtained by integrating optimization objectives into the prediction process. Besides, some practical insights can be drawn through applicability analysis and sensitivity analysis. First, the proposed model is more suitable for intersections where traffic arrivals vary greatly. Second, with the increase of scheme differences within a certain range, the advantages of the proposed method become more obvious. Finally, it is necessary to balance the flexibility of traffic control with control effectiveness in practical applications.

Optimization of Control Method for Roundabout at Fixed Cycle

Traffic Signal Control Optimization Strategy Based on Simulation

Editorial on Advanced Road Traffic Control

Optimal Cycle Calculation Method of Signal Control at Roundabout

Urban Road Roundabout Method of Contrast Optimization and Research

Balanced control method for road network traffic state

Optimization Method of Signal Timing Parameters Considering Comprehensive Efficiency of All Approach Lanes

Coordination Control Strategy of Urban Expressway On-ramp and Off-ramp

Signal control and simulation of a typical roundabout

On-ramp metering control strategy of urban expressway

Traffic Control Strategy for a Surface Street on an Expressway-Arterial Corridor

Isolated intersection control based on integrated saturation degree

Designing Route Guidance Strategy With Travellers' Stochastic Compliance: A Bi-Level Optimal Control Procedure

Approximations and Simulation of the Optimal Change Interval for Roundabout

A Bi-Level Optimal Control Approach to Route Guidance Problem Considering Travelers' Stochastic Compliance

A Semi-"Smart Predict, then Optimize" Method for Traffic Signal Control.

Improvement of classical numerical method for arterial road signal coordinate control

Ideas and Methods for Mixed Urban Traffic Control

Simulation of the Frontage Road Control Near the Expressway Exit Ramp

Research on the Optimal Method of Cycle Length for Signalized Intersection

Isolated intersection control based on hybrid optimization model