Abstract:Zinc-air battery has drawn increasing attention from the whole world owing to its large energy capacity, stable working voltage, environmentally friendship, and low price. A special porous Zn with three-dimensional (3D) network frame structure, whose multistage average pore sizes can be tuned from 300 to 8 um, is synthesized in this work. It is found that there is a competition between Zn2+ and <math>NH4+</math> for their reduction on the supports. And the decrease of Zn2+ concentration and increase of <math>NH4+</math> concentration can facilitate the decrease of pore size. Potential-dynamic polarization was tested with 3-electrodes cell, aiming to characterize the electrochemical activity and corrosion properties of porous Zn and commercial Zn foil electrodes. After optimization, the porous Zn prepared with the parameters of 3 M NaBr, 1 M C2H3O2NH4, and 0.01 M C4H6O4Zn shows the most negative corrosion potential of −1.45 V among all the samples, indicating the remarkable anti-corrosion property. Its discharge specific capacity is up to 812 mAh g−1. And discharge-charge test of the porous Zn shows an initial discharge platform of 1.33 V and an initial charge platform of 1.96 V, performing a small overpotential. What's more, the porous Zn exhibits a much longer cycle life than commercial Zn foil. Our work will not only shed light on the design and synthesis of other porous metal materials, but also further promote the development of Zn-based battery electrochemistry.

On the Influence of Microporous Membrane on the Dehydration of Zinc-Air Battery

Zinc-air battery with microporous membrane

Effects of environmental factors on dehydration of zinc-air battery

On the Influence of Infusion Mass on Discharging Performance of Gas diffusion Electrode in Zinc-Air Battery

Influencing Factors of Performance Degradation of Zinc–Air Batteries Exposed to Air

Experimental Research Of Liquid Infiltration And Leakage In Zinc Air Battery

Preparation of waterproof and air-permeable silicalite-1/PDMS/PTFE membrane by casting method for metal-air battery

Hydrogel electrolyte membrane with regulated pore effect to stabilize zinc anode in aqueous zinc-ion batteries

Fine-Tuning Electrolyte Concentration and Metal-Organic Framework Surface toward Actuating Fast Zn2+ Dehydration for Aqueous Zn-Ion Batteries

On the Zinc Air Battery Electrode Surface Seepage Phenomenon

Microporous Polymer Coatings Enable Uniform Zn Stripping/Plating for Long-Life Aqueous Zinc-Ion Batteries

Porous Zinc Anode Design for Zn-air Chemistry

Recycle and preparation of zinc used for zinc-air battery

Anti‐swelling Microporous Membrane for High‐capacity and Long‐life Zn–I2 Batteries

Experimental research of electrolyte additives and battery performance of aqueous zinc-ion batteries

The inhibition of suitable trace electrolyte on hydrogen evolution of zinc anode and the improvement of zinc battery performance

Effects of Ultrafine Bismuth Powder on the Properties of Zinc Electrodes in Zinc-Air Batteries

Revealing the Effects of Structure Design and Operating Protocols on the Electrochemical Performance of Rechargeable Zn-Air Batteries

Ultrathin and super-tough membrane for anti-dendrite separator in aqueous zinc-ion batteries

Suppression of Zinc Dendrite Growth by Enhanced Polyacrylamide Gel Electrolytes in Zinc‐ion Battery

Fabrication of electrospun CO2 adsorption membrane for zinc-air battery application