Abstract:Under a boundary lubrication regime, the effect of sliding velocity and normal loads on the friction coefficient in the sheet metal stamping process was investigated using a pin-on-disk sliding wear test. Software was used to analyze both the data generated and the friction coefficient; in addition, a variable friction model based on different velocities and normal loads was also initiated. Under different experimental conditions and numerous influences, both the analysis and microtopography examination of sheet metal helped to obtain the mechanism influence on the friction coefficient. Through further analysis of the microtopography of sheet metal, the law of the surface roughness of sheet metal after grinding with stamping die was established. The model was established to simulate the thickness distribution and spring-back of U-bend parts using ABAQUS software. The results show that the friction coefficient values between the sheet metal and the stamping die generally decrease with increasing sliding velocity and normal loads, and the decreasing tendency slows down under a higher sliding velocity and normal load. Furrow wear and abrasive wear are the main wear mechanisms, with slight sticking wear under the boundary lubrication; the surface roughness after grinding with stamping die generally increases with increasing normal loads and decreasing sliding velocity. The predicted results of thickness distribution with a constant friction coefficient of 0.1 and with the variable friction coefficient model are more consistent with the actual measured values, but the predicted accuracy of spring-back in the variable friction coefficient model is higher than that of the constant friction coefficient model.

Numerical Study on Interface Contact Pressure During Stamping

Numerical Analysis of the Effect of Processing Parameters on Temperature on the Contact Interface During High Strength Steel Cold Stamping

Reaearch of finite element modeling & experiment of the die structure for high-strength steel sheet metal stamping

Experimental and Numerical Study on Surface Damage of Dual-Phase Steel Sheet During Stamping

Numerical investigation of tool parameter influence on the interlock forming during flat clinching process

Numerical Study on Viscous Pressure Forming of Sheet Metal

Die Structure Analysis Of Stress Distribution During High-Strength Steel Stamping Process And Experimental Validation

Analysis of Sheet Metal Forming (Stamping Process): A Study of the Variable Friction Coefficient on 5052 Aluminum Alloy

Numerical Simulation on Channel Shape Hot Stamping of 22mnb5 High-Strength Sheet Metal Based on Thermo-Mechanical Coupled Method

Numerical Simulation Analysis of Drive Line Influence Factors on Stamping Part Surface

Investigation of micro/meso sheet soft punch stamping process – simulation and experiments

A Flat Asymptotic Frictionless Contact Subject to Normal Load and Bending Moment

FEM model optimization study of mechanical properties and material selection in stamping process

Effect of discrete roller dies on the contour accuracy of profiles in multi-point flexible stretch-bending forming

Numerical Simulation of Magnetic Pressure in Tube-Electromagnetic Bulging with Die

Strategy to Improve Computation Precision in Inverse Analysis Method of Sheet Metal Stamping

Numerical Simulation of Sheet Flexible - Die Forming Process

Finite element analysis on stamping car cradle with local thickening

Numerical Analysis of Impact of Imprinting Pressure on Profile Shape and Mold Deformation in UV-NIL

Numerical study on forming limit curve in sheet stamping and tube hydroforming

Study on the Effects of Forming Parameters on the Plastic Flow of Axisymmetrical Curved Parts in Stamping Process