Abstract:In a high-temperature test of the gas generator with a free-loading composite propellant, an abnormal jitter appeared in the latter part of the internal ballistic curve, whereas no such abnormality was observed in the low-temperature and normal-temperature tests. To investigate the cause, quasi-steady-state simulations of the internal flow field, as well as strength and buckling simulations of the grain, were conducted. The strength simulation revealed that the maximum stress experienced by the composite propellant during operation at 323 K is 0.7 MPa, which is lower than the ultimate stress of the grain (1.01 MPa), indicating no stress failure. The buckling simulation demonstrated that the instability arises from an imbalance of pressure on the inner and outer surfaces of the grain. In the original structure, the ventilation effect on each surface of the grain varied with the regression of the burning surface, leading to a pressure imbalance on the inner and outer surfaces of the composite propellant. Consequently, a non-ablative cladding layer was applied to ensure that the ventilation effect of each channel remains constant. The simulation demonstrated that the pressure on the surfaces of the composite propellant gradually balanced with the operation of the gas generator. Upon retesting at high temperatures, no abnormal jitter was observed in the internal ballistic curve. This indicates that maintaining a constant ventilation area for the combustion chamber and preventing changes in the ventilation effect can ensure the structural integrity of the composite propellant during operation. The working state of the composite propellant with this non-ablative cladding layer is not affected by variations in the design of the solid rocket motor. This approach enhances the adaptability and reliability of the free-loading composite propellant under different motor structures.

Experimental and Simulated Study on Constant-volume Stage of Cluster Bomb Dispensing System With Center Combustion Gas

Ballistic Modeling and Numerical Simulation of Cluster Bomb with Piston Dispensing and Guiding Tube

Modeling and Simulation of Aerial Dispersion on Piston Dispersal Mechanism

Interior Ballistic Modeling and Numerical Simulation for the Internal Combustion Gasbag of Cluster Munition

Numerical Simulation of the Two-phase Flow of a Constant-pressure Rear-spray Low Recoil Weapon with Two Chambers

An Experimental System of Constant Volume Combustion Bom Bwith Variable Turbulence Parameters

Visualization experiment on the ignition performance and flame-spreading in different charging structures

Simulation and Experimental Research Based on Carrier Gas Flow Rate on the Influence of Four-Channel Coaxial Nozzle Flow Field

Experiment and instantaneous driving simulation of explosion dispersion process of central tube for submunition

Interior ballistic two-phase flow model and its calculation for a mixed charge structure

Simulation of Two-Dimensional Interior Ballistics Model of Solid Propellant Electrothermal-Chemical Launch with Discharge Rod Plasma Generator

Powder flow simulation of a ring-type coaxial nozzle and cladding experiment in laser metal deposition

Theoretical and numerical research on the dynamic launch response of carbon fiber composite cartridges

Study on the Three-Stage Method to Calculation Scattering Parameters of Prefabricated Fragments along the Axis Based on Energy Conservation

Experimental Research on Dynamic Response Mechanism of Thin Cylindrical Shell under Blast Loading

Numerical Study of PBX 9501 Explosive Combustion Process in Confined Space

Numerical simulation of a shock wave experiment apparatus based on the air cannon

Experimental and Simulation Analysis on Spray and Combustion Characteristics for Different Qualities of Diesel

Performance Study of a Gas Cannon with a Laval Nozzle Based on CFD Analysis

Research on Solving the Structural Instability of Composite Propellants by Using Non-Ablative Cladding Layers

Study of Annular Coaxial Powder Feeding Effect on the Characteristics of Laminar Plasma Jet and Atmospheric Cluster Deposition