Abstract:Preparation of emulsions from aqueous fractions of biomass pyrolysis liquid (bio-oil) and 0# diesel was studied under ultrasonic power. The thermogravimetric analysis and combustion characteristics of the optimized emulsions in a particular diesel generator were also investigated. The results show that the mass ratio of aqueous bio-oil fraction to 0# diesel affected the emulsion stability greatly, by factor analysis method, and the optimized emulsion was not stratified for 30 days when the ratio was 1:9 under the following conditions: water:bio-oil mass ratio, 2:1; ultrasonic time, 120 min; formula emulsifier addition (Span-80:Tween-80:Tween-20:n-octanol ratio = 72:9:9:10, wt %), 3 wt % (which was longer than that prepared by mechanical agitation). The density and heat value of the nonstratified emulsions (after 30 days) were similar with those of 0# diesel, because of the low aqueous bio-oil fraction content and wit diesel dilution; however, an increase of more than 38.4% in the dynamic viscosity and a decrease in pH from 5.26 to <3 may result from the concentrated polar oxygenates and carbohydrates in aqueous bio-oil fraction, which were further solubilized in water-in-oil (W/O) emulsion droplets. In addition, ultrasonic emulsification resulted in entropy augmentation and equilibrium tendencies (by thermodynamic analysis). Thermogravimetric analysis of the emulsion shows that there is a weight loss peak that is attributed to residual carbon combustion above 400 degrees C, in addition to a similar hydrocarbon vaporization peak at 180 degrees C with diesel. The existence of residual carbon and the high viscosity of the emulsion might have caused inefficient combustion when the output power of diesel generator was above 1400 W with high feeding amount, which also resulted in higher exhaust gas temperature than diesel feedstock, although microexplosion may have occurred. Moreover, when the output power increased to 1600 W with the emulsion used, the O-2 and NOx emissions decreased 21% and 87.2%, respectively, the CO2 emission increased 13.3%, and the CO and SO2 emissions increased quickly to 5124 ppm and 59 ppm, respectively, compared with pure diesel. The corrosion and blockage caused by coking of the injector were obvious.

Effect of ultrasonic parameters on preparation of crude oil emulsion

Ultrasonication Induced Nano-Emulsification of Thyme Essential Oil: Optimization and Antibacterial Mechanism Against Escherichia Coli

The mechanism of ultrasonic irradiation effect on viscosity variations of heavy crude oil

Bio-Oil Emulsion Fuels Production Using Power Ultrasound

Effect of different oils and ultrasound emulsification conditions on the physicochemical properties of emulsions stabilized by soy protein isolate

Experimental study on the effect of high water cut on the emulsifying properties of crude oil

Ultrasonic treatment of rice bran protein-tannic acid stabilized oil-in-water emulsions: Focus on microstructure, rheological properties and emulsion stability

Ultrasound-assisted desalination of crude oil: The influence of mixing extent, crude oil species, chemical demulsifier and operation variables

Effect of Ultrasonic Pretreatment on the Properties of Bio-Oil

Experimental Study on Ultrasonic Viscosity-Reduction Method of Crude Oil

Influences of ultrasonic treatment on the physicochemical properties and microstructure of diacylglycerol-loaded emulsion stabilized with soybean protein isolate and sodium alginate

Effect of ultrasonic power on the emulsion stability of rice bran protein-chlorogenic acid emulsion

Applying ultrasonic fields to separate water contained in medium-gravity crude oil emulsions and determining crude oil adhesion coefficients

Effect of Ultrasonic Treatment on the Properties and Composition of High-Wax Crude Oil and Its Precipitates

Emulsification of Bio-Oil Heavy Fraction with Diesel by Mechanical and Ultrasonic Technologies

Preparation and Research of Oil in Water Microemulsion

Ultrasonic Preparation of Emulsions Derived from Aqueous Bio-Oil Fraction and 0# Diesel and Combustion Characteristics in Diesel Generator

The dynamics study of microwave demulsification of heavy crude oil emulsion

Fabrication of emulsions prepared by rice bran protein hydrolysate and ferulic acid covalent conjugate: Focus on ultrasonic emulsification

Ultrasound-induced structural changes of different milk fat globule membrane protein-phospholipids complexes and their effects on physicochemical and functional properties of emulsions

Investigation on the mechanism of heating effect influencing emulsifying ability of crude oil: Experimental and molecular dynamics simulation