Abstract:In a pH 5.66 acetate-acetic acid medium, the complex reaction of Al(II) with chlorophosphonazo-mS (MSCPA) is very sensitive. In order to react with Al(III) completely, MSCPA must be added excessively enough. Without doubt, the excess MSCPA in the reaction solution affected the measurement of light-absorption of the Al-MSCPA complex. Thus, ordinary spectrophotmetry is unfit for the measurement of such a complex. To eliminate such an interference, both A(537 nm), and A(618 nm) were selected as the work wavelengths and the spectral correction technique was applied to the characterization of the above complex. The result showed that the composition ratio of Al(III) to MSCPA is 1:1. Using the complexation, a new dual-wavelength approach named the light-absorption ratio variation approach (LARVA) was applied to the determination of trace amounts of Al(III), which often increases the sensitivity up to 10 times better than ordinary spectrophotometry. From the LARVA, the less the MSCPA added, the higher the sensitivity obtained. However, a too low amount of MSCPA caused an obvious error in the measurement because of the noise of instrument background. In the present work, 2.80 micromol x L(-1) MSCPA was added into the Al(III) solution. The absorbance ratio difference (deltaAr) of the Al-MSCPA solution is proportional to the Al(III) concentration in the range of 0 and 0.150 mg x mL(-1). The LOD of Al(III) is only 2 mg x L(-1). The result indicated that many kinds of metal ions did not affect the direct determination of Al(III). Besides, the addition of thiourea solution may mask Fe(III) and Cr(III) effectively. The complexation between Al(III) and MSCPA was completed in 2 min, and the color absorption of solution remained almost constant for more than 1 h. Therefore, a set of continuous flow analysis (CFA) device was designed for the online rapid analysis of Al(III) and coupled with LARVA to increase greatly the analytical efficiency. The results showed that the LOD of Al(III) is 6.5 mg x L(-1) and the analytical rate is about 30 samples per hour. This method has been applied satisfactorily to the determination of trace amounts of aluminum in two chemical reagents, giving recoveries in the range of 97.6%-103.5%.

MICELLAR SOLUBLIZING SPECTROPHOTOMETRIC DETERMINATION OF MICRO COPPER IN ALUMINUM ALLOY

Spectrophotometric Determination of Coper with 2-(5-Nitro-2-pridylazo)-5-methylaminoaniline

PHOTOMETRIC DETERMINATION OF LEAD IN ALUMINUM ALLOYS WITH CHROMOGENIC REAGENT TRIBROMO-METHYLSULFONAZO

Determination of Trace Amounts of Aluminum by Light-Absorption Ratio Variation Combined with Continuous Flow Analysis

Flame Atomic Absorption Spectrometric Determination of Copper and Lead in Beer after Preconcentration Using A Rapid Coprecipitation Technique with 8-Oxyquinoline

SIMULTANEOUS PHOTOMETRIC DETERMINATION OF COPPER AND PALLADIUM WITH 5-(5-NITRO-2-PYRIDYLAZO)-2,4-DIAMINOTOLUENE

Catalytic spectrophotometric determination of trace aluminium with indigo carmine.

Further Improvement of Flame Atomic Absorption Spectrometric Determination for Cu, Pb and Cd After Preconcentration Using a Rapid Coprecipitation Technique

Determination of trace copper in water sample by flame atomic absorption spectrometry with cloud point extraction preconcentration

Measurement of Absorbance Ratio Difference Determination of Trace Amount of Aluminum in Surface Water with Chlorosulfophenol S As Color Reagent

Absorption Ratio-Spectrophotometric Determination of Trace Amounts of Copper( Ⅱ ) in Surface Water by the Color Reaction with Dibromo Alizarin Violet

Competition Coordination Of Copper In Aluminium Solution And Determination Of The Stability Constant Of Their Complexes With Dibromomethyl Dibromocarboxyazo

A Novel Detection Approach Based on Chromophore-Decolorizing with Free Radical and Application to Photometric Determination of Copper with Acid Chrome Dark Blue.

DETERMINATION OF COPPER BY SELECTIVE RELEASING CHELATOMETRIC TITRIMETRY

DETERMINATION OF COPPER AT NG ML -1 LEVEL IN SURFACE WATER USING THE ELECTROPHILIC SUBSTITUTION REACTION BETWEEN CU(II) AND 3-(3-SULFOPHENYLAZO)-6-(4-CHLORO-2-PHOSPONOPHEN- YLAZO)- 4,5-DIHYDROXYNAPHTHALENE-2,7-DISULFONIC ACID-CA(II) COMPLEX

Chronopotentiometric Determination of Aluminum by Solochrome Violet RS

Study on Spectrophotometric Determination of Trace Copper after Flotation Separation Using Microcrystalline Adsorption System Loaded with Cui

Determination of trace copper(Ⅱ) by catalytic kinetic spectrophotometry and research of its reaction mechanism

Study on the Determination Method of the Content of Copper

Ligand-Induced Red-Emitting Copper Nanoclusters for Selective Fluorescence Determination of Aluminum Ions

Spectrofluorimetric Determination of Aluminum Ions Via Complexation with Luteolin in Absolute Ethanol