Abstract:Particle size and content of RDX are the two main factors that affect the burning stability of RDX-based propellants. However, these effects and the corresponding mechanisms are still controversial. In this work, we investigated the physicochemical processes during burning and the corresponding mechanisms through the technologies of structure compactness analysis on the base of voidage measurement and theoretical interfacial area estimation, apparent burning rate measurement using closed vessel (CV) and extinguished burning surface characterization relying on interrupted closed vessel (ICV) and scanning electron microscope (SEM). The results indicate that the voidage increased with the increase of RDX content and particle size due to the increasing interfacial area and increasing interface gap size, respectively. The apparent burning rate increased with the increase of RDX particle size because of the decreasing RDX specific surface area on the burning surface, which could decrease the heat absorbing rates of the melting and evaporation processes of RDX in the condensed phase. Similarly, the apparent burning rate decreased with the increase of RDX content at pressures lower than around 55 MPa due to the increasing RDX specific surface area. Whereas, an opposite trend could be observed at pressures higher than around 55 MPa, which was attributed to the increasing heat feedback from the gas phase as the result of the increasing propellant energy. For propellants containing very coarse RDX particles, such as 97.8 and 199.4 μm average size, the apparent burning rate increased stably with a flat extinguished surface at pressures lower than around 30 MPa, while increased sharply above around 30 MPa with the extinguished surface becoming more and more rugged as the pressure increased. In addition, the turning degree of <em>u</em>-<em>p</em> curve increased with the increase of coarse RDX content and particle size, and could be reduced by improving the structure compactness.

Influence of RDX Content on Mechanical Properties of Heterogeneous Single-base Gun-propellant Characterized by Microphysical Parameter

A new insight into the mechanical behavior of high-quality RDX in pressed polymer bonded explosives

Study on Dynamic Impact and Ignition Response Behavior of GAP/PET/RDX Based Propellant

Characteristic Property of Combustion and Internal Ballistics of Triple-Based Propellant according to Particle Size of RDX

Effects of particle size and content of RDX on burning stability of RDX-based propellants

Superoxide dismutase activity in the nervous system

Preparation, High-Density Spherical, and Low Sensitivity of RDX/NC/PMMA Composite Particles

Influence of different energetic plasticizers on the performance of NC-RDX nitramine gun propellants

Study on Mechanical Properties and Penetration Stability of DNAN Based Explosives Under Additive Effects

Effect of Mechanical Heterogeneity on the Structural Integrity of HTPB Propellant Grain

[New strategies in the treatment of chronic viral hepatitis].

A Novel Method of Improving the Mechanical Properties of Propellant Using Energetic Thermoplastic Elastomers with Bonding Groups

Molecular dynamics simulation of bonding role of cyclic borate ester in improving mechanical properties of the HTPB propellant

Effect of low-concentration RDX dust on solid–liquid mixed fuel characteristics

Experimental Investigation on the Influence of Confining Pressure on Thermal Aged CMDB Propellant

The Effect of Crystal Characteristics and Manufacturing Processes on the Mechanical Properties of Composite Explosive

Mechanical Behaviors and Constitutive Relations under wide strain rate range for CMDB propellant

Study on Preparation and Performance Test of the Flexible Explosive with Higher Energy, Lower Sensitivity

Visco-hyperelastic constitutive modeling of the dynamic mechanical behavior of HTPB casting explosive and its polymer binder

Electrostatic spraying synthesis of energetic RDX@NGEC nanocomposites

Mesoscale mechanics investigation of multi-component solid propellant systems