Abstract:Electrically assisted superplastic forming and diffusion bonding (EASPF/DB) is based on the electrically assisted technique in which the electric current is directly and simply introduced into metallic sheets during hot processing. Through the rapidly increasing heat by the Joule effect after several minutes, the advantages of the EASPF/DB process are further strengthened, and the limitations of commercial exploitation (e.g., long processing period) are partly overcome. In this study, an experimental setup of EASPF/DB was assembled for the experimental validation of this concept. The Ti<sub>2</sub>AlNb alloy sheet, which is regarded as a superior substitute for the nickel-based alloy, was diffusion-bonded and formed, and a double-layer structure was fabricated by means of the EASPF/DB process. The temperature distribution measured by an infrared imaging camera was apparently influenced by detour effects of the electric current. To examine the forming and bonding effects, the height and thickness were measured in different positions. The microstructures of the bonding interface were observed, and no microcavity and crack were found, which indicated the feasibility of the variant of the SPF/DB process. Meanwhile, the large-size grains of B2 phase compose the microstructure of forming zone with some fine needle–like precipitates. Finally, the hardness test showed higher values of Vickers hardness than that of the as-received sheet and the compression test showed three stages of the double-layer structure during continuous loading. The important values and significance for use of this variant are presented by markedly reducing the heating and cooling time and the targeted heating manner for metallic sheets.

Research on Superplastic Forming and Diffusion Bonding of Nickel Based Superalloy

Superplastic Forming and Diffusion Bonding for Four-Layer Sheets Structure of Nickel-Base Superalloy

Superplastic Forming and Diffusion Bonding for Sandwich Structure of Ti-6al-4v Alloy

Numerical Simulation of Superplastic Forming and Diffusion Bonding of Ti Alloys

Research progress in fabrication of nickel-based superalloy components by electron beam powder bed fusion

Research on application of hot isostatic pressing technology in the field of nickel-based cast superalloys

Research Progress of Wrought Superalloys in China

Research on superplastic forming/diffusion bonding technology of Ti2AlNb alloy

Research Progress in Nickel Base Single Crystal Superalloys

Spray formed nickel-base superalloys

The Research and Application of Spray Formed Superalloys

The Structural Design and Superplastic Forming/diffusion Bonding of Ti2AlNb Based Alloy for Four-Layer Structure

Data-Driven Design of Cast Nickel-Based Superalloy and Precision Forming of Complex Castings

Electrically assisted superplastic forming/diffusion bonding of the Ti2AlNb alloy sheet

Research progress on selective laser melting processing for nickel-based superalloy

Superplastic Forming and Diffusion Bonding for Multilayer Structure of Ti-6Al-4V Alloy

Research status on the effect of energy density on the forming microstructure and properties of nickel-based superalloys for laser additive manufacturing

RESEARCH PROGRESS IN BONDING TECHNOLOGY OF TiAl-BASED ALLOYS

Present Research Situation And Prospect Of Hot Working Of Cast & Wrought Superalloys For Aero-Engine Turbine Disk In China

Analysis of Spray Forming and Processing Factors of Superalloy Billets

Spark Plasma Diffusion Bonding of Inconel 718 Superalloys by Using Atomic Cluster Powder Fillers