Abstract:Fault detection for multi-mode process are becoming a hotspot. By effective mode division and accurate online identification, a multi-mode hybrid data set can be transformed into multiple single-mode data sets, then the traditional PCA-based approach can still be adopt to process monitoring. However, in the treatment of “fast response” multi-mode procedure, the above idea does not seem to apply, which is mainly due to: 1) the characteristics of the realtime measurements are needed to be similarity or dissimilarity measured with the known characteristics of all modes, which produces large computational cost, further usually appears online data can not be matched with the monitoring model timely, and finally leads to higher false alarm and missing detection; 2) especially when the running cycle of a single mode is short with less data, and the mode is frequency switched, the situation will be much worse. To this end, aiming at the switching frequently multi-mode, the joint multi-mode hybrid data are used to build a unified model for the case that modes unable to be identified effectively. Meanwhile, the generalized eigenvalues and generalized eigenvectors are defined, and a trade-off fault detection approach is established based on the unified model. Simulation results demonstrate the effectiveness of the new method, which can avoid the monitoring model unapplicable. Moreover, it is real-time and practical.

Fault Detection Techniques Based on Multivariate Statistical Analysis

New Fault Recognition Method Based on Multivariate Statistical Process Control

Fault diagnosis in industrial processes using principal component analysis and hidden Markov model

PCA-based Fault Detection and Diagnosis with Application to Heavy Oil Fractionator

Statistical monitoring of dynamic multivariate processes - Part 2. Identifying fault magnitude and signature

Faults Diagnosis in Industrial Reheating Furnace Using Principal Component Analysis

Multi-mode process monitoring method based on PCA mixture model

SVM-based Multivariate Statistical Process Control Method and Its Application

Sensor Fault Diagnosis with Statistical Signal Reconstruction Approach

Fault Detection Based on Multivariate Trajectory Analysis

Method of Independent Component Analysis and Its Application to Fault Diagnosis

Faults Detection and Isolation Based on PCA: an Industrial Reheating Furnace Case Study

A Data-Driven Fault Detection Framework Using Mahalanobis Distance Based Dynamic Time Warping

Fault detection approach based on linear dynamical system in principal component space

Multi-mode data-based joint fault detection method

Sensor fault identification and isolation for multivariate non-Gaussian processes

Independent Component Subspace Method and Its Application to Fault Detection

Fault Detection in Non-Gaussian Vibration Systems Using Dynamic Statistical-Based Approaches

Multiple Fault Detection Using Multi-Rate Probability Principal Component Analysis Models

Local ICA for Multivariate Statistical Fault Diagnosis in Systems with Unknown Signal and Error Distributions

Fault Detection with Improved Principal Component Pursuit Method