Influence of femoral intramedullary guides on the limb alignment in total knee arthroplasty

卢宏章,朱天岳,柴卫兵
DOI: https://doi.org/10.3969/j.issn.1005-8478.2004.14.003
2004-01-01
Abstract:Objective: The accuracy of the femoral intramedullary system was investigated to demonstrate the alignment error made by the entry point and other factors.Method:Forty patients who received total knee arthroplasty with TACK prosthesis were selected.The entry point of the intramedullary ort was at the center of femoral notch during operation.The FTA,femoral lateral angle were measured on 14×17 inches standing radiographys preoperative and postoperative.Using a mathematical model,the potential angular error in the distal femur cut from aberrant placement of the intramedullary rod was estimated.Result:The anatomic axis was found to exit the distal femur at an average of 7.0mm(0~11mm)medial to the center of the femoral notch.It was more obvious for the genu valgus.Substantial malalignment error resulted from minor malposition of the intramedullary rod.The femoral lateral angle of prosthesis was 80 to 90 degrees postoperative.Some 70% of knees were within 2 degrees of true alignment.According to the mathematic model,if the entry point was at the center of notch,rod placement error resulted in excessive valgus alignment.Conclusion:These results show that the true entry point is medial to the center of the notch,and rod placement error results in excessive valgus alignment.Preoperative drawing of the anatomical axis on 14×17 inches anteroposterior standing radiography is recommended.
What problem does this paper attempt to address?