Abstract:In this study, three different modeling approaches, namely, a model with moving heat source, a model with high effective heat source named instantaneous heat source, and a model with instantaneous heat source as well as coarser mesh density, were employed to systematically investigate welding residual stress and deformation in a multi-pass butt-welded joint. Moreover, the difference of material properties especially yield stress between base metal and weld has been considered. In addition, the hole-drilling method and three-coordinate measuring technique were employed to obtain welding residual stress distribution and deformation, respectively. The comparison between simulation results and measurements suggests that the model with moving heat source can obtain a good prediction of both welding residual stress and deformation, while the model with instantaneous heat source can only provide a reasonable result for welding residual stress but fail to predict welding deformation. However, the latter model can save a large amount of computing time. Numerical results indicate that the mesh density in the longitudinal direction has an insignificant influence on the calculated results of welding residual stress and deformation if the developed instantaneous heat source model has been used. From the viewpoint of engineering application, the model with instantaneous heat source model and coarser mesh density is potentially able to predict welding residual stress distribution in thick-plate joint using a shorter computing time.

Development of Computer Simulation of Weld Joint Microstructure

The evolution of modeling welding microstructures

Development Status of Welding Numerical Simulation Technology

Simulation on Weld Metal Solidifying Microstructure with Cellular Automaton

Simulation of Microstructure During Weld Solidification Based on Cellular Automaton

Microstructure Simulation and Experiment for the Weak Weld Joint of a Domed Storage Tank during an Explosion Based on the Cellular Automaton Method

Advances in numerical simulation of welding temperature field and stress and strain in structural parts

Finite element simulation of welding process and real-time monitoring assessment

Present Situation and Prospect of Welding Simulation Technology

HAZ microstructure simulation in welding of a ultra fine grain steel

Microstructure Simulation of Grain Growth in Heat Affected Zone

Visual simulation method of welding microstructure evolution based on cellular automaton

Study on Cellular Automation Model During Weld Metal Solidifying

Three Dimension Simulation Analysis of the Interpass Stress and Deformation During Multipass Welding

Numerical simulation of GTAW for ZW61 magnesium alloy thin plates: Coupling the finite element method with the cellular automata method

Three-Dimensional Numerical Simulation of Weld Solidification Cracking

Microstructure evolution of HAZ in the multi-pass underwater wet welded joints

Simulating Welding Residual Stress and Deformation in a Multi-Pass Butt-Welded Joint Considering Balance Between Computing Time and Prediction Accuracy

Numerical simulation system for typical aircraft components welding

Simulation of the Global Response of Welded Joint Using Digital Image Correlation Measurement

Numerical Simulation and Microstructure Analysis of 30CrMnMoRe High-Strength Steel Welding