Abstract:The spreading of aqueous solution of fluorinated surfactants on oil is the basis for aqueous film-forming foam( AFFF) to function as fire extinguishing reagent.However,the efficiency of extinguishing is influenced by many parameters and complicated conditions.In this work,the spreading behaviors of aqueous mixtures of sodium perfluorooctanoate (SPFO)and octyltriethylammonium bromide (C_8 NE) on cyclohexane, n-heptane and 90 # gasoline were investigated,in order to compare the discrepancy between different oils during the extinguishing of burning-fire.The results showed that the interaction between cationic-anionic hydrogenated and fluorinated surfactants has strongly enhanced the spreading,in which the single solution of either SPFO or C_8NE is unable to spread.In addition,the combination has also greatly reduced the consumption of fluorinated surfactant.The roles of C_8NE played might be the electrostatic attraction from its headgroup and its adsorption on oil/water interface.Therefore,cost of AFFF formulation could be greatly reduced by the introduction of opposite-charged hydrogenated surfactants.The effects of mixing ratios and total concentration of both surfactants on the spreading rates, spread amount and critical rapid-spread concentration were observed. It showed that,when the total concentration( C,)was low,the aqueous mixtures of SPFO-C-8NE exhibited a minimum surface tension at the ratio of equimolar n (SPFO) : n(C_8NE).Meanwhile,the surfactant mixture with higher total concentration( C_t=5 mmol/L)exhibited much lower surface tension than the case of C_t=1 mmol/L.The measurement of surface tension was performed to provide complimentary data of mechanism discussion.Within the investigated concentration range of those SPFO-C_8NE aqueous mixtures,two factors appeared to be favorable for rapid spreading and spread amount increase, namely higher total concentration of surfactants and close-toequimolar mixing ratio.For the equimolar mixture of SPFO-C_8NE, the sequence of spread amount on different oils was: cyclohexane 90 # gasolinen-heptane.This sequence could be related in term of the surface tension of different oils,and it showed that different burning oils might be extinguished by same fire-extinguishing agent with different extent of difficulty.

Spreading of aqueous mixtures of sodium perfluorooctanoate and octyltriethylammonium bromide on oil

Effect of liquid fuel on foamability and foam stability of mixtures of fluorocarbon and hydrocarbon surfactants

Comparative Study on Interfacial Properties, Foam Stability, and Firefighting Performance of C6 Fluorocarbon Surfactants with Different Hydrophilic Groups

Synthesis and characterization of a novel surfactant used for aqueous film-forming foam extinguishing agent

Fuel effects on aqueous film formation and foam degradation and their impact on fire suppression by foams containing fluorosurfactants

Influence of nanoparticles on rheological properties and foam properties of mixed solutions of fluorocarbon and hydrocarbon surfactants

Formulation and performance of aqueous film-forming foam fire extinguishing agent composed of a short-chain perfluorinated heterocyclic surfactant as the key component

Influence of nano-aluminum hydroxide on foam properties of the mixtures of hydrocarbon and fluorocarbon surfactants

Experimental study on thermal stability and burn-back performance of aqueous film forming foam agent(AFFF) with short-chain fluorocarbon surfactant or flame retardant

Study on the Effect of Nanoparticles Combined with Silicone Surfactant and Cationic Surfactant on Foam and Fire Extinguishing Performance

Role of nanoparticles in the performance of foam stabilized by a mixture of hydrocarbon and fluorocarbon surfactants

Aggregation behavior and foam properties of the mixture of hydrocarbon and fluorocarbon surfactants with addition of nanoparticles

Evaluation of interfacial, micellar, and foaming properties of the solutions comprising fluorocarbon surfactant, cocamidopropyl betaine, and Gleditsia saponin as fire-extinguishing agents

Environmentally friendly fluorine-free fire extinguishing agent based on the synergistic effect of silicone, hydrocarbon surfactants and foam stabilizers

Environmentally Friendly Firefighting Foams Used to Fight Flammable Liquid Fire

Influence of nanoparticles on the foam thermal stability of mixtures of short-chain fluorocarbon and hydrocarbon surfactants

Effect of low pressure on the properties of short‐chain fluorocarbon surfactants and their application in aqueous film‐forming foam extinguishing agent

Systematically Varying Zwitterionic-Siloxane Surfactant Structure to Affect Interfacial Properties, Foam Stability, and Fire Suppression

Experimental investigation on the spread of aqueous foam over ethanol surface

The Study of the Stability of Aqueous Three-Phase Fire-Resistant Foam in Typical Liquidus Hydrocarbons

Gas-liquid surface characterization and liquid film thinning of Non-Aqueous foam