Abstract:Researches of flow and dispersion in urban area are important to meet the practical demands of studies of vehicular exhaust pollution and accidental leakage. Numerical simulations with field observations and physical simulations (e.g., wind tunnel simulation) are often used to address atmospheric flow and dispersion problems in cities. In general, numerical simulations can provide specific detailed informations of flow, turbulence and dispersion. To deal with small-scaled flow and dispersion, computational fluid dynamics (CFD) models are widely applied and are capable of reproducing small-scaled characteristics of flow and dispersion. A CFD model-FLUENT was adopted to simulate the disturbance of a single building on atmospheric flow under the neutral stability condition. Wind tunnel data published by Hamburg University was collected to validate the modeled results and assess the choices of parameters and parameterization schemes. This technique was applied to address atmospheric dispersion problems in quasi-urban building arrays. Concentration data of MUST and a tracer experiment were used to evaluate the dispersion modeling. The results indicated that FLUENT well performed in mean flow simulation under construction disturbance condition. Simulated results for FAC2 of horizontal and vertical modeling wind speed were 77.9% and 61.0% respectively. However, thre was a relatively larger discrepancy between the modeling and measured turbulence characteristics, when the FAC2 of modeling turbulent kinetic energy was 54.6%. The turbulent closure scheme options (i.e., standard K-ε scheme, Re-normalization Group K-ε scheme and Reynolds Stress Model scheme) had trivial effects on simulated results. The dispersion simulation case within quasi-urban buildings was satisfactory. The result of the dispersion case correctly reproduced the irregular plume shifting caused by building disturbance compared to the average wind direction. The modeling concentrations were generally in accordance with measured results, and the relative tolerance of the modeling maximum concentration in lateral profile at 32 and 63 m downwind were 72.5% and 36.9% respectively. Relative to the Gaussian plume model-ISC3, FLUENT can provide more practical concentration distribution under complex conditions. FLUENT simulation also indicated that the maximum lateral concentration decreased along the downwind direction in "step change" pattern between the adjacent street canyons near the release source. The maximum lateral pollutant concentrations in the same street canyon as the source were several times or even one order of magnitude higher than that in the next canyon. FLUENT results can reproduce the phenomena of dispersion towards upwind area and also of accumulation and detouring flow around the constructions. Further researches are required to analyze the phenomena.

Review on Development of Atmospheric Dispersion Models under Low Wind Speed Condition

Atmospheric Dispersion Simulation in Low Wind Conditions in Inland Hills and Valleys

Estimation of Dry Deposition Fluxes of Aerosol Particles in the Qingdao Area Ⅰ: an Improvement on the Growth Effect of Wet Particles in Williams' Model

Study on Conventional Atmospheric Dispersion Models in China, America and Canada

Construction and Validation of an Urban Area Flow and Dispersion Model on Building Scales

Using CALPUFF for Near-Field Atmospheric Dispersion Simulation over Complex Terrain

Normalized Dispersion Prediction Model For Toxic Release Under Variable Wind Conditions

Dispersion Models for Vehicle Exhaust Pollutant

Simulating Flow and Dispersion by Using WRF-CFD Coupled Model in a Built-Up Area of Shenyang, China

Review on Progress in Modeling Dust Emission Caused by Wind Erosion

Simulating Microscale Urban Airflow and Pollutant Distributions Based on Computational Fluid Dynamics Model: A Review

CFD Simulations of Flow and Dispersion under Construction Disturbance Conditions

A dense gas dispersion model based on revised meteorological parameters and its performance evaluation

Atmospheric Dispersion Modeling Using a Stochastic Wind Model

Evaluation of a micro-scale wind model’s performance over realistic building clusters using wind tunnel experiments

Review on Pollutant Dispersion in Urban Areas-Part A: Effects of Mechanical Factors and Urban Morphology

Characteristics and similarity relations of turbulence dispersion parameters under heavy haze conditions

Lagrangian stochastic simulation of atmospheric dispersion from sources near the ground

A study on automotive pollution dispersion modeling in urban streets

A review of the CAMx, CMAQ, WRF-Chem and NAQPMS models: Application, evaluation and uncertainty factors

Simulations of near-source wind development and pollution dispersion over complex terrain under different thermal conditions