Design of digital microphone system

刘彦,陈隆道,祁才君

DOI: https://doi.org/10.3969/j.issn.1002-8684.2003.02.013

2003-01-01

Abstract:The digital microphone system can be divided into two parts--the data transmitter and the remote controller. The hardware circuit design of the system and the communication protocol between the two parts is roughly introduced in this article.

What problem does this paper attempt to address?

Design and Analysis of Models of Digital Baseband Transfer System Based on SystemView

CHEN Jun

DOI: https://doi.org/10.3969/j.issn.1006-7167.2013.10.026

2013-01-01

Abstract:The principle and mathematics model of the transmission system of baseband digital signal is expounded.On the virtual instrument software SystemView,the system circuit simulation model is designed and the parameters of the function model are set.The simulation model is analyzed from time-domain,power-spectrum and eyes pattern and the its results are accorded with theoretical value.
Design and Implementation of a Microphone Array Speech Data Acquisition System

陈晓峰,肖熙

DOI: https://doi.org/10.3969/j.issn.1002-8684.2008.07.009

2008-01-01

Abstract:A design of microphone array hardware and software system for speech data acquisition is introduced. The system transfers the acquired multi-channel data in real-time by the USB2.0 interface, and is easy to use and to extend.
Real-time Bidirectional Data Transmission Based on USB Interface

Kuang Wang

2005-01-01

Abstract:The article designs a real-time bidirectional transmission channel.And it introduces the theory of the design,selects specific chip,introduces the hardware of the channel,and brings forward the method of designing USB firmware,driver,and application.
Design on Wireless Transmission Voice Acquisition System

QIN Yuanxun,LIANG Weiqian,LIU Runsheng

DOI: https://doi.org/10.3969/j.issn.1002-8684.2012.01.015

2012-01-01

Abstract:Based on low-power wireless protocol 802.15 and G.721(ADPCM),this subject develops a wireless transmission of voice control and signal acquisition system with voice capture,wireless transmission,USB device functions,using NRF24L01 as RF modulator,8051F206 as MCU,CY7C68013 as USB device controller.The system with small size and low power consumption can provide high quality voice signal and high data transfer rate.
Design of Digital Radio Call Control Interface Based on dPMR

Zhen YANG,Yi ZHAO,Xiao-kang LIN

DOI: https://doi.org/10.19304/j.cnki.issn1000-7180.2014.07.011

2014-01-01

Abstract:基于dPMR标准,提出了一种呼叫控制层接口的设计方案.介绍了dPMR标准和呼叫控制层的信令格式;数字对讲机三种不同的工作状态并对三种工作状态对讲机的呼叫流程做了说明,基于FPGA平台,利用Verilog HDL语言,对呼叫控制层接口进行了硬件实现,并利用Modelsim进行了仿真验证.
Design of Baseband System for Digital Interphone Based on AMBE2000 and CMX7141

Chao ZHANG,Xiaokang LIN

DOI: https://doi.org/10.3969/j.issn.1002-8684.2012.03.008

2012-01-01

Abstract:A low-end baseband system of digital interphone conforming to dPMR446 standard is introduced in the paper.Vocoder chip AMBE2000 and digital PMR processor CMX7141 are adopted in the design,and 8051 works as the microcontroller in order to reduce cost.Experiment results show that the system realizes digital conversation,and provides clear voice service with high reliability at a low cost.
Design and Implementation of a Novel Wireless Narrow-band Digital Communication System

GAO Xiang,JIA Si-qiang,YANG Xu,LU Qi-yong

DOI: https://doi.org/10.3969/j.issn.1001-893x.2012.09.004

2012-01-01

Abstract:A method is proposed about the design of a novel wireless narrow-band communication system.The method is based on digital source coding and digital channel coding.The method employs techniques such as two-point modulation and second modulation,which is compatible with the standard of Digital Private Mobile Radio(DPMR).The method is implemented through research and development.The result of experiments shows that the receiving sensitivity of the system reaches -110 dBm.The system can meet the demands of long-distance voice communication or long-distance data communication with medium or low bit rate.
Design and Implementation of the Digital Baseband Part of a DAB Transmitter Prototype

柳春笙,陈国庆,王志华,李艳梅,李渤,李德健,吴恩德,窦维蓓,董在望

DOI: https://doi.org/10.3321/j.issn:0372-2112.2001.09.024

2001-01-01

Abstract:The design and implementation of the digital baseband part of a DAB transmitter prototype are introduced.It is composed of ensemble multiplexer,channel encoder and OFDM modulator.The equipment is totally compatible with ETS 300 401 and other related standards.It supports services with various data formats and supplies a convenient user interface with the ensemble multiplexer as well.All of its I/O s and the core parts are implemented using modular desig n based on universal int ernal interface,thus can be flexibly configured accordi ng to different demand.Co mpared with the existing products,it can provide highe r flexibility and operating easiness on a much lower cost level.
Application of Wireless Data Transmission Module in Scheme Design for Wireless Voice Communication

MA Yun,SHI Jun,JI Xiaoyong

DOI: https://doi.org/10.3969/j.issn.2095-347x.2005.06.015

2005-01-01

Abstract:The operation principle and the communicating characters of wireless module are briefly introduced. A practical wireless secure system based on DSP for voice communication shows the difficulties in the application of the module in detail, which involves the half-duplex protocol, means to synchronize and storage of the data, etc. The method can be universally used on the design of wireless module application.
Design of simplex wireless call and data transmit system based on MCU

Li Jie

Abstract:Based on MCU, a simplex wireless call and data transmit system is designed by analog frequency modulation technique. In the frequency interval of 30～40 MHz, the transmittal of long distance and simplex by small power that voice signals are inputted through microphone and line is realized. The host and subordinate machines can undertake smart communication by frequency shift keying(FSK)modulation mode. There are 256 subordinate stations in our architecture, forming a one-to-multiple point, simplex, wireless call system. There is no obvious distortion and low bit error rate during transmittal. The number of subordinate stations can optionally change, while the host station can selectively or wholly dial-up. Data transmits while voice signals communication in this system. The English words, Chinese characters, short messages and station number will be displayed on liquid crystal display(LCD).

Computer Science,Engineering
Design of 8-Channel Microphone Array System Based on ADSP-21369

WEN Lei,XIAO Xi

DOI: https://doi.org/10.3969/j.issn.1002-8684.2013.08.011

2013-01-01

Abstract:An 8- channel microphone array signal processing system based on ADI's high- performance floating point processor ADSP- 21369 interfacing with the CS5368 A / D converter is designed and implemented in this paper.Because of the employment of high speed floating point DSP processor,the system is powerful for carrying out varied complicated signal processing.This implemented system is applied to speech enhancement application and performs satisfactorily.
Design of Virtual Device System Based on DSP

刁红泉,张瑶瑶,颜钢锋

DOI: https://doi.org/10.3969/j.issn.1671-7147.2004.01.010

2004-01-01

Abstract:With the development of the computer technology and digital signal processing technology, virtual technology has become popular. Application of virtual technology in control domain is called virtual device. To verify the effect of the controller, on the basis of system model, the virtual device with approximate input-output characteristics is employed for the system's real-time simulation, achieving the aim of reducing on-spot debugging, enhancing controller's security and improving effect. This paper presents hardware and software designs of a virtual device using DSP chip-TMS320F240, TI Com. and verifies the simulation effect of virtual device through application example.
Design of Wireless Communication System Based on nRF905

Zhou Chao,Wang Chen

2009-01-01

Abstract:This paper introduces a wireless communication module based on Atmega128L of Atmel and single-chip RF transceiver chip nRF905 of Nordic,and introduces the system working principle,hardware design and software design,and gives out the main procedures. This system has Advantages of low cost,easy expansion,easy operation,etc.,can be widely used in remote control,wireless data collection and other fields.
Design of Low Power Small Microphone Array Speech Data Acquisition System

ZHANG Guo-xian,LIANG Wei-qian,YUAN Kun,ZHANG Chun

DOI: https://doi.org/10.16311/j.audioe.2009.02.013

2009-01-01

Abstract:A design of low power small microphone array speech data acquisition system using MSP430F427 and CY7C68013 is described.The method to acquire and store three channels data synchronously is discussed.The problem of USB2.0 data communication and data post-disposal is assressed.The system is low power consumption,small size and good expansibility.
DiSEqC and Design of Its Hardware Interface

陈丽苹,梁坚,张明,王匡

DOI: https://doi.org/10.3969/j.issn.1002-8692.2004.05.018

2004-01-01

Abstract:Basic knowledge of DiSEqC is introduced, including its concept, advantages, signal coding format, etc. The hardware interface design for DiSEqC is described in terms of its transmitting end and receiving end. The simulation result is also given.
Design of Speech Data Acquisition System Based on Wireless

张国先,刘润生,张春

DOI: https://doi.org/10.16311/j.audioe.2009.11.028

2009-01-01

Abstract:A design of speech data acquisition system using LPC2368,CY7C68013 and NRF24L01 based on embedded technology and wireless communication is developed.It holds function of data acquisition,wireless communication,data storage and USB2.0 communication.The implementation of 2.4 GHz RF wireless communication and USB2.0 data communication technology are discussed.The system is of small size,low power consumption,good expansibility and reliability.
A Wideband MIMO Underwater Acoustic Communication Experimental System

Zheng Gong,Yezhou Wu,Fengzhong Qu,Yuyang Feng

DOI: https://doi.org/10.1109/imcec.2018.8469690

2018-01-01

Abstract:This paper introduces the realization of a wideband MIMO underwater acoustic (UWA) communication experimental system. The system aims at the inherent characteristics of shallow sea acoustic channel with reasonable hardware design. The DT9836 and the DT9816 are used as multifunction data acquisition (DAQ) modules for transmitter and receiver respectively. The USB is used as the communication interface between the underlying hardware equipment and the host computer with QuickDAQ software. The system is verified for its reliability and practicability through the experiments in an anechoic tank and Zhoushan shallow sea area.
On the design of digital base-band processing unit for dPMR system

Yang Zhen,Zhao Yi,Lin Xiaokang

DOI: https://doi.org/10.1109/ICCT.2013.6820454

2013-01-01

Abstract:The digital Private Mobile Radio (dPMR) is a standard for digital trunked system which is proposed by European Telecommunications Standards Institute (ETSI). The protocol describes the Physical Layer (PL), the Data Link Layer (DLL) of Air Interface (AI), and the standardized services and facilities of the mobile radio. In this paper, we propose a Digital Base-band (DBB) processing unit, including Micro Control Unit (MCU), call control interface, channel codec and base-band modem, etc. The DBB solution is realized by Verilog HDL, simultaneously, Modelsim software is adopted to simulate all the modules of the DBB unit. The simulation and verification show that the designed DBB unit for dPMR works as excepted.
Design of Digital Module for Transmitter of GSM Handset

郭玲,杨佳宁,李挥,吴晔,谢亨骏

DOI: https://doi.org/10.3969/j.issn.1002-0802.2010.08.035

2010-01-01

Abstract:The digital module for PLL(phase locked loop) direct modulation of GSM RF transmitter chip is designed. This digital module of transmitter achieves the differential coding, Gaussian filtering, channel coding, multi-polar noise shaping of the digital base-band data, provides PLL frequency ratio, and realizes the choice of transmitting or receiving channels. Through modeling and simulation with Matlab, the structural design of each module, code-level RTL design and preparation of the corresponding test-bench for functional verification are conducted. Then, Modelsim simulation is carried out and the predetermined requirement achieved. Finally, this design adopts TSMC0.18μm CMOS technology, and a RF chip named as CHRF06/GSM/E-GSM/DCS/PCS is thus fabricated.
Design and Implementation of Serial Communication Based on DSP

ZHANG Kun-chan,YANG Jian-hua,DU Xin-hu

DOI: https://doi.org/10.3969/j.issn.1002-2279.2010.06.009

2010-01-01

Microprocessors

Abstract:A TMS320LF2407A-based serial communication system was developed to realize communications between digital signal processor(DSP) and other controllers.This system employed an Universal Asynchronous Receiver Transmitter(UART) module and a Serial Peripheral Interface(SPI) module to connect the DSP to a host PC and a client display peripheral respectively.Detailed principle and method for hardware design were introduced;communication programs and relative software structure were given.Communication experiments showed that the system was simple in circuit design and stable and accurate in data transmission.It has reference value and practical benefit to exploit communications of DSP system.

Design of digital microphone system

Design and Analysis of Models of Digital Baseband Transfer System Based on SystemView

Design and Implementation of a Microphone Array Speech Data Acquisition System

Real-time Bidirectional Data Transmission Based on USB Interface

Design on Wireless Transmission Voice Acquisition System

Design of Digital Radio Call Control Interface Based on dPMR

Design of Baseband System for Digital Interphone Based on AMBE2000 and CMX7141

Design and Implementation of a Novel Wireless Narrow-band Digital Communication System

Design and Implementation of the Digital Baseband Part of a DAB Transmitter Prototype

Application of Wireless Data Transmission Module in Scheme Design for Wireless Voice Communication

Design of simplex wireless call and data transmit system based on MCU

Design of 8-Channel Microphone Array System Based on ADSP-21369

Design of Virtual Device System Based on DSP

Design of Wireless Communication System Based on nRF905

Design of Low Power Small Microphone Array Speech Data Acquisition System

DiSEqC and Design of Its Hardware Interface

Design of Speech Data Acquisition System Based on Wireless

A Wideband MIMO Underwater Acoustic Communication Experimental System

On the design of digital base-band processing unit for dPMR system

Design of Digital Module for Transmitter of GSM Handset

Design and Implementation of Serial Communication Based on DSP