Abstract:In order to study the dynamic characteristics and destabilisation damage mode of the accumulation body slope under the action of ground vibration, and to provide theoretical guidance and technical support for the optimization design of reinforcement of similar slopes, a large shaking table model (scale 1:16) test with a specific accumulation body slope was conducted as a prototype. The dynamic response and deformation characteristics of the model slopes were observed by inputting sine, Wolong, and EI Centro waves to the bottom of the model slopes, respectively. The test results showed that in the vertical direction and on the slope surface, the acceleration amplification factor (AAF) increased with the increasing of altitude, and presented a nonlinear change. In the horizontal direction, the AAF increased with distance from the slope surface. There was also a slope surface amplification effect with the AAF reaching its maximum at the slope shoulder. Similar laws were obtained after numerical simulation of the prototype slope by FLAC3D software. Different types of seismic waves exhibited different effects on the AAF. Sine waves showed the largest effect, followed by Wolong waves, and EI centro waves exhibited the smallest effect. The AAF of the modelled slope was different for different input wave frequencies. As the input frequency of Sine waves increased, the AAF increased first and then decreased. This change coincided with the AAF reaching its maximum value at 25–30 Hz. The AAF of the modelled slope varied when the input wave amplitude values were different. When the AAF reached its maximum value, the input amplitude was 0.4 g. By analysing the slope failure progression, it showed that the slope of an accumulation body began with local sliding at the front edge, followed by internal sliding of it, and the overall sliding.

Flac3d simulation for dynamic response of the slope under explosion loading

Numerical Simulation of Dynamic Damage and Stability of a Bedding Rock Slope under Blasting Load

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Three-Dimensional Transient Response of Deep Embedded Tunnels to Internal Explosions

Computer Simulation of Dynamic Brittle Damage Process in Arch Dam Due to Blast Load

Influence of Lithology on the Characteristics of Wave Propagation and Dynamic Response in Rocky Slope Sites Subject to Blasting Load Via the Discrete Element Method

Fracture mechanics analysis of rock containing collinear cracks under dynamic blasting loads

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Field Test and Elastic Dynamic Response Analysis of Shallow-Buried Utility Tunnel under Explosion Load

Seismic dynamic response characteristics and failure mechanisms of an accumulation body slope

Dynamic response of cylindrical deep buried tunnels in unsaturated soil under axisymmetric explosion loading

DYNAMIC RESPONSE OF UNDERGROUND ARCH STRUCTURE UNDER SIDE BLAST LOAD

3D FINITE ELEMENT ANALYSIS OF ANISOTROPIC BRITTLE DYNAMIC DAMAGE IN GRAVITY DAM UNDER BLAST-IMPACT LOAD

Dynamic Response Simulation of the Slope Triggered by Fluctuating Pressure during High Dam Flood Discharge

The destructive form and response analysis of buried concrete pipes under the action of internal explosion loads

Seismic dynamic responses and acoustic emission criteria of a horizontal soft–hard interbedded slope

Investigation on the Seismic Wave Propagation Characteristics Excited by Explosion Source in High-Steep Rock Slope Site Using Discrete Element Method

Study on load distributing function of square slab surface under the action of underwater close‐in blast loading

Dynamic Response of Slopes under Earthquakes

Three-Dimensional Numerical Simulation Study on Rock Slope Stability