Numerical Simulation on Optimization of Shrinkage Cavity Defect of Steel SCM822H 3 t Ingot
Yang Wanliang,Li Jingshe,Yang Hongbo,Song Fangfang,Huang Ting
DOI: https://doi.org/10.3969/j.issn.1003-8620.2013.05.005
2013-01-01
Abstract:Based on the measured value of ingot surface temperature in ingot stripping at situ,with using ProCAST software the calculation model for filling and solidifying process of 3 t ingot(body height 1 675 mm,hot top inclined angle 65.3°,height of liquid surface in hot top 290 mm) of steel SCM822H(/%:0.20C,0.80Mn,0.25Si,0.013P,0.006S,1.14Cr,0.39Mo,0.01V,0.036A1,0.0002B) has been established.With calculation by the model the relation between hot top inclined angle,ingot body height-width ratio and body cut-off volume ratio caused by shrinkage cavity is gotten to get the optimized ingot parameters i.e.body height-width ratio 1 846/630 and hot top inclined angle 90°.According to optimized ingot mould parameters the simulation results show that with using the new ingot mould the ingot body cut-off volume ratio decreases from original 13.5%to 0,it is available to ensure all the shrinkage cavity is in the hot top.