Abstract:The Pancharatnam–Berry (PB)-phase liquid crystal (LC) planar optical elements, featuring large apertures and a light weight, are emerging as the new generation optics. The primary method for fabricating large-aperture LC planar optical elements is through photo-alignment, utilizing polarization laser direct writing. However, conventional polarization direct writing suffers from an inertia-induced stopping step during splicing, leading to suboptimal optical effects. Here, we propose a novel highly efficient method for arbitrary polarization patterning, significantly reducing interface splicing errors in these optical elements. (We call it dynamic polarization patterning technology). This process involves simultaneous mobile splicing and real-time generation of different polarization patterns for exposure, eliminating the inertia-related splicing interruption. As a demonstration, we fabricated a lens with an aperture of approximately 1 cm within 30 min at 633 nm. Furthermore, we developed a 100% fill-factor lens array (3 × 3) with an element lens diameter of approximately 7 mm within 1.5 h at 532 nm. Their focal lengths were uniformly set at 30 cm, demonstrating superior convergence capabilities within their designated working wavelengths, alongside commendable performance in converging light across various other wavelengths. Our measurements confirmed the good focusing performance of these samples. The convergence spot size of the lens deviated by approximately 40% from the theoretical diffraction limit, whereas the lens array exhibited a deviation of around 30%. The dynamic polarization direct writing during uniform platform movement reduced splicing errors to a mere 100–200 nm. The enhancement in imaging quality can be primarily attributed to the innovative use of mobile polarization splicing exposure technology, coupled with the inherent self-smoothing properties of LC molecules. This synergy significantly mitigates the impact of seam diffraction interference.

Polymer Network Liquid Crystal (PNLC) Lenticular Microlens Array with No Surface Treatment

Optically anisotropic, electrically tunable microlens arrays formed via single-step photopolymerization-induced phase separation in polymer/liquid-crystal composite materials

Switchable Liquid Crystal Lenticular Microlens Arrays Based on Photopolymerization-Induced Phase Separation for 2D/3D Autostereoscopic Displays.

Phototunable Microlens Array Based on Polymer Dispersed Liquid Crystals

Submillisecond-Response Polymer Network Liquid Crystal Phase Modulators

Electrically Tunable Microlens Array Enabled by Polymer‐Stabilized Smectic Hierarchical Architectures

Dynamic Polarization Patterning Technique for High-Quality Liquid Crystal Planar Optics

Research and Application: Liquid Crystal Devices Fabricated by Single-Exposure Photoalignment

Preparation of a Thermally Light-Transmittance-Controllable Film from a Coexistent System of Polymer-Dispersed and Polymer-Stabilized Liquid Crystals

Adaptive Lenticular Lens Array Using a Hybrid Liquid Crystal–carbon Nanotube Nanophotonic Device

Liquid Crystal Lens with a Shiftable Optical Axis

Cooperative Liquid Crystal Photo‐Polymerization and ‐Alignment with In Situ Monitoring for Substrate Independent Patterning of Optical Anisotropy

Fabrication of Polymer Microlens Array with Controllable Focal Length by Modifying Surface Wettability

Liquid crystal microlens arrays with switchable positive and negative focal lengths

Bistable Polymer-Dispersed Cholesteric Liquid Crystal Thin Film Enabled by a Stepwise Polymerization

Polyimide Liquid Crystal Alignment Layers Prepared by Soft-Lithography

Dielectric Liquid Microlens Array with Tunable Focal Length Based on Microdroplet Array Created via Dip-Coating Method

Hysteresis-free and submillisecond-response polymer network liquid crystal.

PDLC with controllable microstructure using wavelength-selective two-stage polymerization