Abstract:In many engineering problems, it is customary to use viscoelastic materials in the passive control of structural vibration and noise radiation. The most commonly used numerical tool to obtain detailed information on the performance of complex structures is the finite element (FE) method. However, structures with viscoelastic materials often require very large-scale FE computational models to obtain reliable predictions, which makes original full-order system evaluation intractable due to memory and time limitations. In order to alleviate these problems, model order reduction techniques have become indispensable. Most of them, however, often do not handle complex-valued and especially frequency-dependent system matrices well. Due to the frequency dependency of the material properties, the FE equations of motion for viscoelastic models are not of a standard second-order form as that for regular elastic FE models. In this paper, a new transformation technique based on Taylor’s theorem is introduced to treat the frequency-dependent shear modulus. After transforming the problem into a second-order system equation with remainder term, an adaptive second-order Arnoldi method is applied for the reduction of the computational complexity of structures, incorporating classical free- and constrained-layer damping treatments. In support, a relative error indicator is developed to iteratively enrich the reduced model and determine the position of expansion points used in next step. Three widely used models, the Golla–Hughes–McTavish model, Generalized Maxwell model and Fractional Derivative model for describing the frequency-dependent property of viscoelastic materials are investigated in order to demonstrate the simplicity, versatility and efficiency of the proposed approach.

Model Reduction for Dynamic Analysis to Rod Component with Frequency-Dependent Damping

Numerical Model for Vibration Damping Resulting from the First Order Phase Transformations

A Simplified Analytical Model for U-shaped Steel Dampers Considering Horizontal Bidirectional Deformation

A Dynamical Model with Order Reduction for a Fluidic Bending-Type Soft Actuator

Physical Essence and Influence of Model Parameters on Dynamic Response of Rayleigh Damping

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Adaptive model reduction technique for large-scale dynamical systems with frequency-dependent damping

Parameter identification for stiffness and damping of active magnetic bearing in flexible rotor system

MODEL REDUTION OF RIGID-FLEXIBLE COUPLING DYNAMICS OF HUB-BEAM SYSTEM

Model Order Reduction of Thermo-Mechanical Coupling Flexible Multibody Dynamics Via Free-Interface Component Mode Synthesis Method

Fast Dynamic Analysis of Beam-Type Structures Based on Reduced-Order Model

A Universal Rate-Dependent Damping Model for Arbitrary Damping-Frequency Distribution

Dynamic Modeling and Analysis of Centrifugally Stiffened Proportionally Damped Timoshenko Beam

Iterative Dynamic Condensation Method of Finite Element Model for Rotor-Bearing System

Dynamic Modeling and Analysis of Distributed Rod Fastening Rotor

Nonlinear Dynamic Analysis of Rub-Impact Rod-Fastening Combined Rotor Systems with Internal Damping

Reduced-Order Modeling For Stability And Steady-State Response Analysis Of Asymmetric Rotor Using Three-Dimensional Finite Element Model

Analytical Modeling Method of Dynamics for the Spindle Rotor System

A Reduced Order Model for Joint Assemblies by Hyper-Reduction and Model-Driven Sampling

Theoretical dynamic reduction for steady-state nonlinear vibration responses of complex jointed structures having hysteretic contact behavior

Dynamic modeling of a sliding ring on an elastic rod with incremental potential formulation