Abstract:Magnesium alloys are potentially attractive biodegradable materials. However, their rapid corrosion rate limits their biomedical application. To slow down the rate of biodegradation, a protective calcium-phosphate coating was formed on a magnesium alloy substrate by a hydrothermal method. Scanning electron microscope results showed that the coating consisted of two layers with different crystalline characteristics. The loose outer layer showed a prism-like crystal structure, while the compact inner layer is a dense ultra-fine regular di-pyramid-like structure with an average grain dimension of ∼200 nm. The compositions of the inner layer and outer layer were calcium-deficient hydroxyapatite (Ca-def HA) and dicalcium phosphate (DCPa), respectively. The coating adhered well to the substrate with a thickness of about 15 μm. Immersion in Hank’s solution indicated that the coating could significantly improve the degradation properties of magnesium alloy. The pH of the solution containing the coated samples increased much more slowly than the untreated control. After 8 d immersion, the uncoated sample had corroded seriously while the coated sample was much less corroded. The Ca/P atom ratio in both the layers of the coating increased and the coating was still protecting the substrate. The two layers of the coating corroded differently because of differences in solubility. The outer layer was more severely attacked and many holes were formed on the surface, the inner layer suffered less attack. In addition, a growth of precipitate on the inner layer was observed, indicating that surface bioactivity was improved by the coating. Thus, magnesium alloys coated with a Ca-P coating prepared by a hydrothermal method are promising candidate biodegradable biomaterials, and further investigation of in vivo degradation behavior is suggested.

Hydrothermal calcification of bioglass film in CaHPO4 solutions

Morphologies of Hydroxyapatite Crystal Deposited on Titanium Surface with Electrochemical Technique

Hydrothermally Crystallized Sr-containing Bioactive Glass Film and Its Cytocompatibility

Sol‐gel Preparation and Properties of Ag‐containing Bioactive Glass Films on Titanium

Hydrothermal Calcification of Alkali Treated Titanium in CaHPO4 Solution

Microstructure of bioglass/hydroxyapatite coatings on Ti substrate

Fabrication and properties of HAP-bioglass-Ti6Al4V composite

Surface modification of a Ti-7.5Mo alloy using NaOH treatment and Bioglass coating

Preparing Ca-P Coating on Biodegradable Magnesium Alloy by Hydrothermal Method: in Vitro Degradation Behavior

Sol-gel-synthesized bioglass-ceramics: physical, mechanical, and biological properties

Hydroxyapatite Coating on Ti6Al4V Alloy by a Sol–gel Method

Sol-Gel Preparation and Preliminary in Vitro Evaluation of Fluorapatite/Hydroxyapatite Solid Solution Films

Characterization of sodium alginate containing bioactive glass coatings prepared by sol–gel processing

Formation of a nanostructured layer on bioglass particles of different sizes immersed in tris-buffered solution. N2 adsorption and HR-TEM/EDS analysis.

Characterisation and Mechanical Adhesion of HAP/TiO2 Composite Films on Ti6Al4V Processed by Sol-Gel Method

Ti-Glass Biocomposite Coating Materials and Their Crystallization Dynamics

Effect of Hydrolysis Coefficient on Bioactivity of Sol-gel Derived Bioglasses

Hydrothermal Growth of TiO2-CaP Nano-Films on a Ti–Nb-based Alloy in Concentrated Calcium Phosphate Solutions

Sol–gel preparation of bioactive apatite films

Hydrothermal Pre-calcification and Bioactivity of Medical Near beta-Type Titanium Alloy TLM

Structural behavior and in vitro bioactivity evaluation of hydroxyapatite-like bioactive glass based on the SiO2-CaO-P2O5 system