Abstract:The twin tails of the modern high performance fighter aircrafts with delta wing/twin vertical tails configuration generally experience significant dynamic load due to aerodynamic buffet caused by highly unsteady vortex breakdown flow.This paper proposes a new type of buf-fet alleviation method by solid static or oscillating bulges attached on the forebody of a delta wing model,and conducts wind tunnel experiment for the model which consists of a sharp-edged,70-degree leading edge sweep delta wing,and twin 31°leading edge sweep vertical tails.The model has been tested at 10m/s and 20m/s of free stream velocity,and at angle of attack ranging from 20°to 50°with an interval of 2°in the low-speed wind tunnel at Northwestern Polytechnical Uni-versity.According to the self-induced theory proposed by experts from University of Washing-ton,the bulges attached on the forebody of a delta wing would twist and kink the vortex core, change the vortex trajectory after the bulge,delay the vortex breakdown position,and decrease the fluctuating level of the flow around the twin vertical tails.Thus the goal of buffeting suppres-sion is achieved.This study aims at investigating the buffet alleviation effect of the static or vi-brating bulges attached on the forebody surface of the model.Two pairs of half bridged strain gauges are employed for the measurement of unsteady root strain on the vertical tails,with one pair on each side.The experimental results show that both static and vibrating bulges behave positively as a novel tool to alleviate tail buffet,and the alleviation effect correlates with the vi-brating frequency.Besides,the bulge on one side can only alleviate the buffeting for the tail of the same side,and it has no obvious alleviation effect for the tail on the opposite side.Results of spectral analysis prove that the bulges used in this experiment could alleviate tail buffeting,but they do not change the dominant frequency of the oscillation of the tails in the vortex breakdown flow.

Active Vertical Tail Buffeting Suppression Based on Macro Fiber Composites

Piezoelectric Active Control for Tail Buffeting at High Angle of Attack

Design of Fin Buffeting Piezoelectric Active Alleviation System and Ground Model Testing

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

Active Vibration Control Based on Piezoelectric Smart Composite

Design of Multiple Dynamic Vibration Absorbers for Buffet Control of Vertical Tails

A New Approach to Identify Buffet Loads for Aircraft Vertical Tail

Experimental study on a novel method for vertical tail buffet suppression

Macro fiber composite-based active and efficient suppression of low-frequency vibration of thin-walled composite beam

MIMO Multi-Frequency Active Vibration Control for Aircraft Panel Structure Using Piezoelectric Actuators

Postponing The Onset And Alleviating The Load Of Transonic Buffet By Using Steady And Periodic Tangential Slot Blowing

Aeroelastic Stability Analysis of Curved Composite Panels with Embedded Macro Fiber Composite Actuators

Research on Active Vibration Control of Flexible Wing Based on MFC Actuator

Prediction of ultimate load for aircraft vertical tail buffeting

Active Dynamic Vibration Absorber for Flutter Suppression

Modeling Techniques for Active Shape and Vibration Control of Macro-Fiber Composite Laminated Structures

Adaptive active vibration control for composite laminated plate: Theory and experiments

Nonlinear Flutter Response of Heated Curved Composite Panels with Embedded Macrofiber Composite Actuators

Experimental and Computational Investigation of Novel Vertical Tail Buffet Suppression Method for High Sweep Delta Wing

Adaptive Vibration Suppression of Time-Varying Structures with Enhanced FxLMS Algorithm

Active suppression of panel flutter with piezoelectric actuators using eigenvector orientation method