Abstract:Using the recently developed single shear specimen, deformation behavior of 304 austenitic stainless steel is studied systematically over a wide range of strain rates, covering quasi-static (0.001-0.1 s−1), medium (1-10 s−1), high (3000-6000 s−1) and very high (13000-39000 s−1) regimes, and temperatures between 77 and 1073 K were considered. The experimental flow stress curves show that: (1) the flow stress increases slightly at strain rates below 6000 s−1; concerning strain rates above 13000 s−1, however, an obvious flow stress upturn exists; (2) dynamic strain aging (DSA) occurs within the temperature range of 673 to 873 K and strain rates lower than 10 s−1; (3) both temperature sensitivity and strain rate sensitivity of the material are affected by DSA, and bell-shaped sensitivity curves form; (4) with increasing strain rates, peaks of the bell-shaped temperature sensitivity curves move to higher temperature regimes, and the evolution law is equally valid for the influence of temperature on the strain rate sensitivity curves. According to experiments, eight constitutive relations, including three phenomenological, four physical-based, and an artificial neural network, are established, including viscous drag effect at very high strain rates but excluding DSA phenomenon. Prediction capacities of the established constitutive models are checked by testing condition jump tests at randomly chosen strain rates and temperatures. Description capacities of the constitutive models in terms of strain hardening rate, temperature sensitivity and strain rate sensitivity are also analyzed.

Simulation of Thermo-Viscoplastic Behaviors for Aisi 4140 Steel

Visco‐Plastic Constitutive Model for Cyclic Responses Simulation and Lifetime Prediction of Hot‐Work Tool Steel H13 at Elevated Temperature

A Study on the Flow Behavior of 42crmo Steel under Hot Compression by Thermal Physical Simulations

Constitutive Model for High Temperature Plastic Deformation of Low Carbon Steel

Constitutive Modeling of Flow Behavior and Processing Maps of a Low-Carbon Steel

Study on Variable Parameter Arrhenius Model of Thermal Compression Stress-strain Relationship of Extruded 42CrMo Steel

Stress–Strain Response of AISI H13 Steel Subjected to Cyclic Thermomechanical Loading

Analysis of Thermal Deformation Behavior and Workability of 37crs4 Special Steel

A Physically-Based Constitutive Model for Sa508-Iii Steel: Modeling and Experimental Verification

Constitutive equation and processing map for hot compressed as-cast Ti-43Al-4Nb-1.4W-0.6B alloy

Hot Deformation Behavior and Comparison of Different Constitutive Models of As-Cast ER8 Steel

Physical Based Constitutive Model for the Prediction of Plastic Deformation of Fe‐Cr‐Ni Stainless Steel Under High Strain Rate

Effect of temperature and strain rate on the compressive deformation behavior of 42CrMo steel

Modelling of Hot Compressive Deformation Behaviour of 55 Steel Considering Strain

Constitutive Modeling for Elevated Temperature Flow Behavior of 42crmo Steel

Thermo-viscoplastic behavior and constitutive relations for 304 austenitic stainless steel over a wide range of strain rates covering quasi-static, medium, high and very high regimes

Mathematical Modeling of High-Temperature Constitutive Equations and Hot Processing Maps for As-Cast SA508-3 Steel

Constitutive Modeling for Elevated Temperature Flow Behavior of 30cr2ni4mov Ultra-super-crical Rotor Steel

Constitutive Analysis on High-Temperature Flow Behavior of 3Cr-1Si-1ni Ultra-High Strength Steel for Modeling of Flow Stress

Constitutive Modeling of Hot Deformation Behavior of X20cr13 Martensitic Stainless Steel with Strain Effect

Hot Deformation Behavior and a Two-Stage Constitutive Model of 20mn5 Solid Steel Ingot During Hot Compression.