Abstract:CFD methodology for subcooled flow boiling is significantly affected by the heat flux partitioning model, which plays a crucial role in predicting the mass source term generated by wall boiling of the liquid phase. Although numerous models have been proposed, most research efforts have focused on the spatial dimensions of boiling heat transfer mechanisms, neglecting the temporal aspect. This study presents a heat flux partitioning model for subcooled flow boiling that considers both temporal and spatial dimensions. The model accounts for the contribution of heat flux from the superheated liquid layer during the bubble growth stage, liquid convection during the bubble wait stage within the bubble influence area in the temporal dimension, and heat flux from the overlapping area of bubble influence in the spatial dimension. An approach was developed to determine the bubble influence area by considering the bubble interaction based on the stochastic nature of nucleation sites on the heated wall, verified by the Monte Carlo method. The bubble dynamics parameters were experimentally derived to reduce the uncertainty associated with the boiling sub-models on the calculation. A comparative analysis of boiling curves and wall heat flux partitioning was conducted between the present model and the RPI model under various flow conditions. The results indicate that both models could reasonably predict the boiling curve. However, the RPI model tends to over-predict the proportion of evaporative heat flux, which is considered a weakness. Based on physical principles, the present model accurately captures the fundamental trend of wall heat flux partitioning. This research enhances the understanding of subcooled flow boiling and increases confidence in multiphase CFD methodology predictions.

Experimentally investigating heat transfer and boiling characteristics for the downward facing wall heating

Experimentally investigating effects of gap size and injection flowrate on heat transfer and boiling characteristics for the downward facing wall heating

Investigating Effects of Heating Orientations on Boiling Heat Transfer and Bubble Dynamics for Pool Boiling on Downward Facing Heating Surface

Investigating Effects of Heating Orientations on Nucleate Boiling Heat Transfer, Bubble Dynamics, and Wall Heat Flux Partition Boiling Model for Pool Boiling

Subcooled Pool Film Boiling Heat Transfer from Spheres with Superhydrophobic Surfaces: an Experimental Study

Observing Investigation of Boiling Characteristics Around CHF for the Downward Facing Heating Surface

Experimentally investigating boiling characteristics in the transition boiling for the downward facing heating

Experimental investigation on the characteristics of bubble growth and slide on a downward-facing heater surface in flow boiling

Numerical Study on Bubble Behaviour and Heat Transfer Characteristics of Subcooled Pool Boiling Based on Non-Empirical Boiling and Condensation Model

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Experimental and computational investigation on two-phase flow and heat transfer of highly subcooled flow boiling in vertical upflow

Investigation of bubble dynamics and boiling heat transfer characteristics under vertically heating walls via lattice Boltzmann method

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

Study on evaporation induced flow characteristics and interfacial phenomena of water in a sidewall-heated cylindrical pool at low pressures

Transient wall temperature response during liquid nitrogen nucleate pool boiling: CFD analysis and experimental validation

Experimental Study of Saturated Pool Boiling from Downward Facing Structured Surfaces

Examination of two-phase behaviors in porous media during pool boiling

Heat transfer enhancement of helical tubes during pool boiling

Numerical simulation of boiling behavior in vertical microchannels

Experimental Analysis of Fast-Transient Flow Boiling in Various Flow Conditions Using Inverse Heat Conduction Calculation Method