Abstract:Background and objectives: Laser surgical procedures involving photocoagulation of soft tissue have relied on subjective visual endpoints. The thermal damage to the denatured tissue in these procedures is highly dependent on the tissue temperatures achieved during laser irradiation. Therefore, a system capable of real time temperature monitoring and closed loop feedback was used to provide temperature controlled photocoagulation (TCPC). Study design/materials and methods: The TCPC system consisted of a 1.32 microns Nd:YAG laser, an infrared thermometer, and a microprocessor for data acquisition and feedback control. A porcine skin model was used. Tissue welds were completed to evaluate the photocoagulation effects at different predetermined temperatures. A quantitative measurement of tissue photocoagulation was obtained by tensile strength measurements of the laser repairs. Histology of the irradiated tissue was used to determine the extent of thermal injury associated with different photocoagulation temperatures. Results: The TCPC system was capable of maintaining a relatively constant temperatures (+/- 4 degrees C) during laser irradiation. The tensile strengths of acute repairs increased with temperature over the range studied (65-95 degrees C). Tensile measurements made after several days of healing showed that higher temperature (95 degrees C) welds had lower strengths than repairs completed at lower (65 degrees C or 75 degrees C) temperatures and were significantly lower at 3 days. Acute histology showed that the amount thermal damage was strongly dependent on the tissue temperature and increased both in tissue depth and lateral to the repair with temperature. The histologic results suggest that the increase in the acute repair tensile strength as the weld temperature increased was due to an increase in the depth of tissue photocoagulation. The increase in the lateral tissue injury measured histologically for higher temperature welds likely resulted in the decreased chronic tensile strengths, as a healing response to excessive thermal damage. Conclusion: Tissue temperatures can be controlled during laser photocoagulation of skin. The degree of acute and chronic tissue damage is highly dependent on the temperature during welding. By controlling the tissue temperature during laser procedures, the surgical outcome can be more reliably predicted and reproduced, as compared to the conventional open loop methods. In addition, the use of a TCPC system should significantly reduce the learning curve for photothermal surgical procedures.

Self temperature regulation of photothermal therapy by laser-shared photoacoustic feedback

A Laser Pumped Nd3‐doped YAG Fiber‐optic Thermal Tip for Laser Thermotherapy

Multi-Wavelength Photoacoustic Temperature Feedback Based Photothermal Therapy Method and System

Photothermal Therapy Method Based on Precise Regulation of Photoacoustic Temperature

A photoacoustic temperature measurement method combined with quantitative absorption distribution

Photoacoustic-Based-Close-Loop Temperature Control for Nanoparticle Hyperthermia

Closed-loop Photothermal Therapy System Based on Photoacoustic and Ultrasonic Dual-Mode Temperature Feedback

Photothermal Therapy Method Based on Photoacoustic/ultrasonic Dual-Mode Temperature Measurement and Regulation

Photoacoustic thermal-strain measurement towards noninvasive and accurate temperature mapping in photothermal therapy

Thermoelectric‐Feedback Nanocomposite Hydrogel for Temperature‐Synchronized Monitoring and Regulation in Accurate Photothermal Therapy

Deep-tissue temperature mapping by multi-illumination photoacoustic tomography aided by a diffusion optical model: a numerical study.

Peltier-based temperature regulation: A method for performance optimization in solid-state lasers

Thermal Memory Based Photoacoustic Imaging of Temperature

Technique Development for Photoacoustic Imaging Guided Interventions

Temperature-controlled laser photocoagulation of soft tissue: in vivo evaluation using a tissue welding model

Mild-temperature Photothermal Treatment Method and System Based on Photoacoustic Temperature Measurement and Control.

Temperature-feedback Upconversion Nanocomposite for Accurate Photothermal Therapy at Facile Temperature.

Temperature control system for frequency stabilization of total internal cavity microchip laser

A Design Method of Temperature Controller for High-Precision Laser

Temperature-feedback two-photon-responsive metal-organic frameworks for efficient photothermal therapy

Towards phase-sensitive optical coherence tomography in smart laser osteotomy: temperature feedback