Abstract:In this paper, an eight-port antenna array is presented for 5G handheld terminals to support multiple-input multiple-output (MIMO) operations. The reported design involves three layers: the top contains eight circular microstrip feed elements; the middle is a low-cost FR-4 substrate, and the bottom layer is a ground plane with four etched octagonal slots. Each resonating element is fed by 50-ohm sub-miniature connectors. To mitigate the detrimental effects of mutual coupling of ports and enhance overall isolation between the adjacent microstrip-fed circular patch elements, a neutralization line is strategically implemented between the feed lines of the antenna array. The design configuration involves two elements at each vertex of the printed circuit board (PCB). The overall dimensions of the PCB are 150 × 75 mm2. Each slot and its corresponding radiating elements exhibit linear dual polarization and diverse radiation patterns. The proposed antenna design achieves the required operating bandwidth of more than 1000 MHz spanning from 3 to 4.2 GHz, effectively covering all the upper C-band frequency range of 3.3 GHz to 4.2 GHz allocated for 5G n77 and n78 frequency range 1 (FR1). Required port isolation and lower envelop correlation coefficient (ECC) are achieved for the band of interest. The proposed design gives a peak gain of up to 4 dB for the said band. In addition to these results, degradation in the performance of the antenna array is also investigated during different operating modes of the handheld device. Measured results from the fabricated unit cell and whole array also have a good match with simulated results. On the whole, the proposed antenna possesses the potential to be used in 5G and the open radio access network (ORAN) compliant handheld devices.

Array antenna with high isolation based on EBG structures for ETC applications

A Novel Compact Dual-Band Antenna Array With High Isolations Realized Using the Neutralization Technique

An Isolation Enhancement Method for a Circularly Polarized Shared-Aperture Array using Rotating Feed

Design of A High Isolation Dual-Polarized Slot-Coupled Microstrip Antenna

Dual-Polarization Aperture-Coupled Microstrip Element and Array Antenna with High Isolation

A Dual-Band Dual-Polarized Antenna Array with Improved Isolation

Broadband and High-Gain Circularly Polarized Antenna by Using EBG Structures

A Simple-Structured Dual-Polarized Staggered Array With Enhanced Isolation at E- and H-Planes

A Compact Dual-Band Orthogonal Circularly Polarized Antenna Array with Disparate Elements

A High Isolated Dual-frequency Dual-polarized Ku-band Microstrip Array Antenna

A Dual-Band Circularly Polarized Stacked Array Antenna with High Isolation for Satellite Communication

Design of a High Isolation and Dual-polarized Antenna for 2G/3G/LTE Base Stations

Design of a Dual-Polarized Linear Microstrip Antenna Array with High Isolation

A Compact Dual-Polarized Double E-Shaped Patch Antenna with High Isolation

The design and decoupling of TX/RX antenna with omnidirectional conical beam operating at V band

Dual-polarized slot-coupled microstrip antenna with very high isolation

Circularly Polarized Antenna Array with Suppressed Sidelobes for Electronic Toll Collection

Microstrip Antennas Integrated with Electromagnetic Band-Gap (EBG) Structures: a Low Mutual Coupling Design for Array Applications

Wideband Dual-Polarized Magnetically Coupled Patch Antenna Array with High Port Isolation

A Compact C-Band Multiple-Input Multiple-Output Circular Microstrip Patch Antenna Array with Octagonal Slotted Ground Plane and Neutralization Line for Improved Port Isolation in 5G Handheld Devices

A Low-profile Dual-band Dual-polarization Co-aperture Array Antenna with High Isolation