Design, Fabrication, and Test of a High-Strength Uniform Pressure Actuator

Zhangzhe Li,Xiaotao Han,Quanliang Cao,Qi Xiong,Liang Li

DOI: https://doi.org/10.1109/tasc.2016.2531992

IF: 1.9489

2016-01-01

IEEE Transactions on Applied Superconductivity

Abstract:Electromagnetic forming using a uniform pressure actuator (UPA) has advantages for forming many components, such as car door pockets, cell phone cases, and fuel cell panels. However, how to generate magnetic pressures on sheet metal with enough high uniformity and high strength is a challenging issue. To improve the strength of the coil, current UPAs were machined out of a solid block of high-strength copper alloy, but its strength was still limited. In this paper, the design idea of pulsed high-field magnets has been applied to improve the coil's strength in a better way. A UPA with high strength has been designed, fabricated, and tested. A series of simulation analysis and experiments have been done; it has been found that the uniformity of the magnetic force on sheet would be increased with the decrease of the wire spacing and the wire width. In addition, the experiment results show that sheets with a thickness of 1 mm can be effectively deformed with a maximum of 14.6 mm under 2.88-kJ energy and the deformation of the sheet is in high uniformity along the direction perpendicular to the wire.