Dynamic Polymer Substrates with Increasing Stiffness for Regulating Smooth Muscle Cells
Xifeng Liu,Lei Cai,Shanfeng Wang
DOI: https://doi.org/10.3389/conf.fbioe.2016.01.02992
IF: 5.7
2016-01-01
Frontiers in Bioengineering and Biotechnology
Abstract:Event Abstract Back to Event Dynamic polymer substrates with increasing stiffness for regulating smooth muscle cells Xifeng Liu1, Lei Cai1 and Shanfeng Wang1, 2 1 The University of Tennessee, Knoxville, Department of Materials Science and Engineering, United States 2 The University of Tennessee, Knoxville, Institute of Biomedical Engineering, United States Cardiovascular tissues bear constant blood shear and dynamic hardening under diseased conditions, which causes the tissue stiffness varies all the time. To mimic the dynamic changing environment in the vessel tissues and investigate the influence of dynamically changing substrate mechanical properties on the cell behaviors, we fabricated a model polymer network from poly(e-caprolactone) triacrylate that can gradually stiffen in 24 h through impeded crystallization at body temperature (37ºC). Rat primary smooth muscle cells (SMCs) were cultured on both static and dynamic substrates and distinct SMC attachment, proliferation and spreading were found. Quantification of contractile gene expression and protein content showed that the dynamic substrates could facilitate the contractile conversion process of SMCs. The analysis of focal adhesions and integrin expression indicated that the cellular abilities to sensing and adhering to the substrate surface were enhanced by the dynamic stiffening stimulation. These results extend the knowledge about SMC mechanosensing to dynamic substrates with increasing stiffness, and demonstrate a new method of regulating SMC adhesion, growth, and functional conversion on substrates. We have developed biodegradable and photo-crosslinkable poly(ε-caprolactone) triacrylates (PCLTAs) that can be photo-crosslinked into networks with high gel fractions and controllable thermal and mechanical properties[1]-[3]. Elastic modulus ranging from 1 to 200 MPa was achieved by modulating the crosslinking density and crystallinity through the nominal molecular weight (Mn) of the polymer[2],[3]. When the molecular weight increases from 2000 to 20000 g/mol, the PCL network changes from an amorphous, compliant elastomer to a semi-crystalline, stiff material with a crystallinity of 42%. For the semi-crystalline PCLTA networks, the melting temperature (Tm) of the substrate increased from 13.8ºC for Mn of 5000 g/mol to 50.4ºC for Mn of 20000 g/mol. Because of the constraints of the crosslinks, polymer crystallization in a network is suppressed and impeded, as demonstrated by reduced crystallinity and slower crystallization. By controlling the Tm of the PCLTA network to be slightly above 37ºC, PCL segments in the network crystallized very slowly at 37ºC and the substrate stiffness increased gradually with the increase in crystallinity over a time period of 24 h. Based on this unique mechanism of impeded polymer crystallization in PCLTA networks, we explore to apply this spontaneously increasing substrate stiffness to regulate SMCs when they are seeded on the substrates and cell attachment occurs at the same time. To study the effect of the gradually increasing substrate stiffness on SMC adhesion, spreading, proliferation, and phenotypic conversion, we prepared a series of PCLTA networks, melted and crystallized at 37ºC for 0, 4, 8, or 24 h. The PCLTA synthesized in this study had Mn of 7985 g/mol, weight-average molecular weight of 9626 g/mol, and polymer molecular weight distribution of 1.206. Figure 1. Scheme of PCLTA photo-crosslinking and crystallization at 37°C. Figure 2. (a) The elastic modulus (G') of the PCLTA networks as monitored using a rheometer at 37ºC. (b) The strain-stress curves for four melted amorphous PCLTA networks pre-treated at 37ºC for 0, 4, 8, and 24 h, respectively. (c) Tensile modulus of these networks at 37ºC. Figure 3. (a) SMC attachment rate on the dynamic and static networks at 4 h post-seeding, as normalized to that on TCPS positive control. (b) SMC spread area calculated at 12 h and day 1 post-seeding on these substrates. (c) SMC numbers at 12 h, days 1, 2, and 4 post-seeding on the dynamic and static samples using TCPS as positive control. *: p < 0.5 to the 24 h static sample. $: p < 0.5 to the 0 h dynamic sample. Conclusions: SMCs receiving dynamic stiffening stimulation had stronger focal adhesions and higher expression of environmental sensing integrin subunits. SMC attachment, spreading, proliferation, and expression of contractile gene markers and calponin protein were all promoted upon receiving the dynamic mechanical stimulation. National Science Foundation (DMR-11-06142)References:[1] Cai L. Polymer 2010, 51(1), 164-77.[2] Wang K. Adv Healthcare Mater 2012, 1, 292-301.[3] Cai L. Langmuir 2012, 28(34), 12557-68. Keywords: cell phenotype, polymer, Cell modulation, matrix-cell interaction Conference: 10th World Biomaterials Congress, Montréal, Canada, 17 May - 22 May, 2016. Presentation Type: General Session Oral Topic: Mechanobiology of cells on biomaterials Citation: Liu X, Cai L and Wang S (2016). Dynamic polymer substrates with increasing stiffness for regulating smooth muscle cells. Front. Bioeng. Biotechnol. Conference Abstract: 10th World Biomaterials Congress. doi: 10.3389/conf.FBIOE.2016.01.02992 Copyright: The abstracts in this collection have not been subject to any Frontiers peer review or checks, and are not endorsed by Frontiers. They are made available through the Frontiers publishing platform as a service to conference organizers and presenters. The copyright in the individual abstracts is owned by the author of each abstract or his/her employer unless otherwise stated. Each abstract, as well as the collection of abstracts, are published under a Creative Commons CC-BY 4.0 (attribution) licence (https://creativecommons.org/licenses/by/4.0/) and may thus be reproduced, translated, adapted and be the subject of derivative works provided the authors and Frontiers are attributed. For Frontiers’ terms and conditions please see https://www.frontiersin.org/legal/terms-and-conditions. Received: 28 Mar 2016; Published Online: 30 Mar 2016. Login Required This action requires you to be registered with Frontiers and logged in. To register or login click here. Abstract Info Abstract The Authors in Frontiers Xifeng Liu Lei Cai Shanfeng Wang Google Xifeng Liu Lei Cai Shanfeng Wang Google Scholar Xifeng Liu Lei Cai Shanfeng Wang PubMed Xifeng Liu Lei Cai Shanfeng Wang Related Article in Frontiers Google Scholar PubMed Abstract Close Back to top Javascript is disabled. Please enable Javascript in your browser settings in order to see all the content on this page.