Abstract:It has been widely considered that the global warming was induced by the increasing atmospheric concentrations of carbon dioxide, which has a significant impact on the sustainable development of the human society. Injecting carbon dioxide into depleted oil / gas reservoir has been developed to reduce carbon dioxide emission by the sequestration of CO2 underground, which is also considered as one promising approach to enhance oil recovery simultaneously. The evaluating of CO2 sequestration in oil reservoir needs highly accurate experimental data and models about the thermodynamic characters of CO2 + oil mixture. Density is one of key physical characters for simulating the diffusion and migration of carbon dioxide under the oil / gas reservoir. Research on volumetric behaviour is helpful to understand the expansion of the liquid phases in CO2 + oil mixture.In this paper, decane is investigated instead of petroleum because of the similar thermal physical property. The measurements have been performed at pressures from 12 MPa to 18 MPa and temperatures from 313.15 K to 343.15 K at four compositions x(1) (x(1) is the mole fraction of carbon dioxide) = 0.8690, 0.9135, 0.9430 and 0.9818 by a magnetic suspension balance (MSB). The accuracy of the experimental quantities presented in this work are T / K = +/- 0.01, m / g = +/- 10(-5) respectively. One circulation pump (AKICO, Japan) is equipped to accelerate the dissolution of CO2 in decane. Some conclusions can be obtained from the experiment as follow: (1) the dissolution of CO2 increases the density of decane, the density of CO2 + decane solution increases with increasing pressure and decreases with increasing temperature. (2) the slope of density with respect to pressure increases with increasing CO2 mole fractions while the slope with respect to temperature decreases with increasing CO2 mole fractions. (3) the crossover phenomenon appears at different compositions and the crossover pressure increases with temperature. (4) the excess molar volumes of this binary mixture are negative and show negative increasing with temperature for the data reported in this work. The GERG - 2008 model is used to predict density of CO2 + decane solution, which takes temperature, pressure, and CO2 concentration into account. An empirical equation is also used to predict the density of this binary mixture. The predictions show that the empirical equation is in good agreement with the experimental data over the experimental range. The measurement and the model used in this work supplies the basic experimental data and theoretical analysis to CO2 sequestration and enhance oil recovery. (C) 2013 The Authors. Published by Elsevier Ltd.

Determination of P–V–T–x Properties of the CO2–H2O System Up to 573.15 K and 120 MPa—Experiments and Model

Experiment based modeling of CO2 solubility in H2O at 313.15–473.15 K and 0.5–200 MPa

Density Measurement and PC-SAFT/tPC-PSAFT Modeling of the CO2 + H2O System over a Wide Temperature Range

An experimental study of PVTx properties in the gas phase for binary mixtures of HFO-1234yf and HFC-134a

Equation of State of the H2O, CO2, and H2O–CO2 Systems Up to 10 GPa and 2573.15 K: Molecular Dynamics Simulations with Ab Initio Potential Surface

High Temperatures and High Pressures Brillouin Scattering Studies of Liquid H2O+CO2 Mixtures

Density Data of Two (H2 + CO2) Mixtures and a (H2 + CO2 + CH4) Mixture by a Modified Burnett Method at Temperature 673 K and Pressures Up to 25 MPa

Determination of Pressure in Aqueo-Carbonic Fluid Inclusions at High Temperatures from Measured Raman Frequency Shifts of CO2

Pvt Measurements Of The H-2-Co2-Ch4-Co-H2o System At 740-939 K And 18.1-34.7 Mpa With An Isochoric Apparatus And The Development Of A Virial Equation Of State

Determination of water solubility in supercritical CO2 from 313.15 to 473.15 K and from 10 to 50 MPa by in-situ quantitative Raman spectroscopy

Densities And Excess Volumes Of Co2 + Decane Solution From 12 To 18 Mpa And 313.15 To 343.15 K

Density and Volumetric Properties of Binary Mixtures of CO2 + Hexadecane from (303.2 to 473.2) K and Pressures Up to 50.0 MPa

A Novel Method for Pressure-Density-temperature-composition Reconstruction of Water-Bearing CO2/CH4-rich Geofluids Based on a High-Precision Raman Calibration Model

Quantitative Raman spectroscopic investigation of geo-fluids high-pressure phase equilibria: Part I. Accurate calibration and determination of CO 2 solubility in water from 273.15 to 573.15 K and from 10 to 120 MPa

High-Pressure Vapor–Liquid Equilibria for a CO2 + P-Cymene Binary System at Temperatures from 313.15 to 353.15 K

Molecular Dynamics Simulation of the CH4 and CH4–H2O Systems Up to 10gpa and 2573K

Measurement and Modeling of the Densities for Co2 + Dodecane System from 313.55 K to 353.55 K and Pressures Up to 18 Mpa

In Situ Raman Spectroscopic Study of the Pressure Effect on the Concentration of Co2 in Water at Hydrate-Liquid Water Equilibrium Up to 900 Bar

Monte Carlo Simulations of High-Pressure Phase Equilibria of Co2-H2o Mixtures

Density Measurements of the H-2-CO2-CH4-CO-H2O System by the Isochoric Method at 722-930 K and 15.4-30.3 MPa

(P, Ρ, T) Behavior of CO2 + Tetradecane Systems: Experiments and Thermodynamic Modeling