Enhancement study of turbulent heat transfer performance of nanofluids in the clover static mixer

Yanfang Yu,Deao Li,Huibo Meng,Jiawei Zhang,Kexin Xiang,Wen Li

DOI: https://doi.org/10.1016/j.ijthermalsci.2024.108900

IF: 4.779

2024-04-01

International Journal of Thermal Sciences

Abstract:The static mixing inserts are considered as an efficient alternative in the process intensification of thermal engineering. In this work, the enhancement characteristics of heat transfer of nanofluids in a Clover static mixer (CSM) were investigated by experiment and Computational Fluid Dynamics. Effects of volume fraction (φ) and nanofluids types on the heat transfer under Re = 2640–17600 are studied by Nusselt number (Nu), local convective heat transfer coefficient (h local), friction coefficient (f) and radial flow number (R). The numerical prediction errors of Nu and f are less than ±11 % compared to the experimental values. The results reveal that utilizing single nanofluids (Cu, CuO and Al2O3) with φ = 0.3%–1.5 % can enhance the heat transfer ability with the average Nu increasing by 99.78%–386.63 %, 5.06%–24.21 % and 10.48%–47.79 % and the average f slightly increasing by 8.25%–15.84 %, 7.46%–14.42 % and 6.71%–13.39 % compared with that of water, respectively. The augment capacity of Cu–Al2O3-water hybrid nanofluids is better than the other three hybrid nanofluids with Nu and EEC reducing by 20.85%–30.61 % and 20.08%–29.02 % than that of Cu-water nanofluids with the same φ. Moreover, the enhancement performance of heat transfer of nanofluids in CSM behaves poorly under low flow rate at Re ≤ 1500, so it is recommended to use nanofluids at high flow rate at Re ≥ 2640. The total entropy production of three single nanofluids with φ = 0.3%–1.5 % decreases 100.83%–405.95 %, 5.82%–28.99 % and 11.28%–53.51 %, respectively.

engineering, mechanical,thermodynamics